SYSTEM INITIALIZATION
Perform additional service for operating the power window control system normally after installing rear door glass. Refer to Work Procedure.
FITTING INSPECTION
Check that the glass is fitted securely into the sash groove.
Lower the glass slightly [approximately 10 to 20 mm (0.39 to 0.79 in)], and check that the clearance to the sash is parallel. Loosen each mounting bolt to correct the glass position if the clearance between the glass and sash are not parallel.
Removal and InstallationRefilling
WARNING:
The ignition switch OFF.
Recommended fluid and capacity: Refer to Fluids and Lubricants.
CAUTION:
Carefully fill the fluid. (Fill up for approximately 3 minutes.)
Leave the vehicle for 3 minutes, and check the fluid level again.
Install filler plug on transfer and tighten to the specif ...
Wiring Diagram
BATTERY POWER SUPPLY FUSE No. 27
Click link to Wiring Diagram.
BATTERY POWER SUPPLY FUSE No. 30
Click link to Wiring Diagram.
BATTERY POWER SUPPLY FUSE No. 55
Click link to Wiring Diagram.
BATTERY POWER SUPPLY FUSE No. 58
Click link to Wiring Diagram.
BATTERY POWER SUPPLY FUSE No. 133
Click link to ...
Commercial Service Tools
Tool name
(TechMate No.) Description Pressure gauge
Checking fuel pressure Quick connector release
Removing fuel tube quick connectors in engine room
(Available in SEC. 164 of PARTS CATALOG: Parts No. 16441 6N210) Leak detector
i.e.: (NI-41416)
Locates the EVAP leak EVAP service port adapte ...