INSTRUMENT PANEL
Most incidents are caused by contact and movement between:
Cluster lid A and instrument panel
Acrylic lens and combination meter housing
Instrument panel to front pillar garnish
Instrument panel to windshield
Instrument panel mounting pins
Wiring harnesses behind the combination meter
A/C defroster duct and duct joint
CAUTION:
CENTER CONSOLE
Components to pay attention to include:
Shifter assembly cover to finisher
A/C control unit and cluster lid C
Wiring harnesses behind audio and A/C control unit
DOORS
Pay attention to the following:
Finisher and inner panel making a slapping noise
Inside handle escutcheon to door finisher
Wiring harnesses tapping
Door striker out of alignment causing a popping noise on starts and stops
Tapping or moving the components or pressing on them while driving to duplicate the conditions can isolate many of these incidents. The areas can usually be insulated with felt cloth tape or insulator foam blocks from the Nissan Squeak and Rattle Kit (NI-50397) to repair the noise.
TRUNK
In addition look for the following:
Trunk lid dumpers out of adjustment
Trunk lid striker out of adjustment
Trunk lid torsion bars knocking together
A loose license plate or bracket
MOONROOF/HEADLINING
Moonroof lid, rail, linkage or seals making a rattle or light knocking noise
Sunvisor shaft shaking in the holder
Front or rear windshield touching headlining and squeaking
SEATS
Cause of seat noise include:
Headrest rods and holder
A squeak between the seat pad cushion and frame
Rear seatback lock and bracket
UNDERHOOD
Causes of transmitted underhood noise include:
Any component mounted to the engine wall
Components that pass through the engine wall
Engine wall mounts and connectors
Loose radiator mounting pins
Hood bumpers out of adjustment
Hood striker out of adjustment
Work FlowCharge Refrigerant
WARNING:
Always use HFO-1234yf for A/C refrigerant. If CFC-12 or HFC-134a is accidentally charged, A/C compressor is damaged due to insufficient lubrication.
Always observe and follow precautions described on refrigerant container. Incorrect handling may result in an explosion of refrigerant contain ...
Exploded View
Bracket Side oil seal Rear final drive assembly Differential lock position switch Rear cover Gasket Drain plug Stud bolt Filler plug O-ring : N·m (kg-m, in-lb) : N·m (kg-m, ft-lb) : Always replace after every disassembly. : Apply gear oil. : Apply Genuine Liquid Gasket, Three Bond 1217 ...
Lower Anchors and Tethers for CHildren System (LATCH)
LATCH system lower anchor locations - models with 2nd row captain's seats
LATCH system lower anchor locations - models with 2nd row bench seat
Lower Anchors and Tethers for CHildren System (LATCH)
Basic information
The Nissan Armada is equipped with a dedicated child safety anchoring ...