Chevrolet Sonic manuals

Nissan Armada 2025-2026 Service and Repair Manual: Work Flow

CUSTOMER INTERVIEW

DUPLICATE THE NOISE AND TEST DRIVE

1) Close a door.

2) Tap or push/pull around the area where the noise appears to be coming from.

3) Rev the engine.

4) Use a floor jack to recreate vehicle “twist”.

6) Raise the vehicle on a hoist and hit a tire with a rubber hammer.

CHECK RELATED SERVICE BULLETINS

If a TSB relates to the symptom, follow the procedure to repair the noise.

LOCATE THE NOISE AND IDENTIFY THE ROOT CAUSE

REPAIR THE CAUSE

CAUTION:

NOTE:

Always check with the Parts Department for the latest parts information.

The following materials are contained in the NISSAN Squeak and Rattle Kit (NI-50397) are listed on the inside cover of the kit; and can each be ordered separately as needed.

URETHANE PADS [1.5 mm (0.059 in) thick]

Insulates connectors, harness, etc.

INSULATOR (Foam blocks)

Insulates components from contact. Can be used to fill space behind a panel.

INSULATOR (Light foam block)

80845-71L00: 30 mm (1.18 in) thick, 30 × 50 mm (1.181 × 1.969in)

FELT CLOTHTAPE

UHMW (TEFLON) TAPE

SILICONE GREASE

SILICONE SPRAY

Used when grease cannot be applied.

DUCT TAPE

Used to eliminate movement.

CONFIRM THE REPAIR

Squeak and Rattle Trouble Diagnoses
...

Inspection Procedure
INSTRUMENT PANEL Most incidents are caused by contact and movement between: Cluster lid A and instrument panel Acrylic lens and combination meter housing Instrument panel to front pillar garnish Instr ...

Other materials:

Exploded View
Front bumper fascia assembly U nut Front side spoiler RH Front spoiler Front side spoiler LH : Rivet : Always replace after every disassembly. ...

Diagnosis Procedure
CHECK STEERING TELESCOPIC MECHANISM Check for the following. Mechanism deformation or pinched foreign materials. Interference with other parts because of poor installation. Is the inspection result normal? YES>> GO TO 2. NO>> Repair or replace the malfunctioning parts. CHECK TELESCOPI ...

Work Procedure
CAUTION: Always use CONSULT for the decel G sensor calibration and side G sensor calibration. (It cannot be adjusted other than with CONSULT.) CHECK THE VEHICLE STATUS Steer the steering wheel to the straight-ahead position. Stop the vehicle on level surface. Stop the engine. Ignition switch OFF (A ...

© 2014-2026 Copyright www.niarmada.com
 
0.0068