Removal and Installation
WARNING:
- Jacking up or lifting up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air suspension component parts. Refer to Precaution for when Jacking and Lifting Up the vehicle with Electronic Air Suspension System (With electronic air suspension).
- When checking under the vehicle or inside wheel house, always turn OFF the electronic air suspension function with the vehicle unladen and normal height, since the suspension may accidentally move and it can lead to personal injury. Refer to Precaution for Electronic Air Suspension System (With electronic air suspension).
REMOVAL
CAUTION:
-
Perform lubricant return operation before each refrigeration system disassembly. However, if a large amount of refrigerant or lubricant leak is detected, never perform lubricant return operation. Refer to Perform Lubricant Return Operation.
-
When disconnect the A/C piping related parts, cap or wrap the joint of those parts with suitable material such as vinyl tape to avoid the entry of air.
Use a refrigerant collecting equipment (for HFO-1234yf) to discharge the refrigerant. Refer to Recycle Refrigerant.
Remove front heater outlet pipe assembly. Refer to Removal and Installation.
Remove front heater pipe assembly. Refer to Removal and Installation.
Disconnect 12V sub battery harness 1 connectors 
, 
, 
, and 
(with 12V sub battery models).
Disengage fixing clip, and then move 12V sub battery harness 1 to secure work space (with 12V sub battery models).
 |
: Clip |
Disconnect low-pressure flexible hose from low-pressure pipe. Refer to Removal and Installation.
Remove low-pressure pipe mounting nuts .
Remove mounting bolt , and then disconnect low-pressure pipe from front expansion valve.
Remove mounting bolt , and then disconnect low-pressure pipe from rear cooler pipe assembly.
Remove low-pressure pipe from tube clip 2 
.
Remove low-pressure pipe from vehicle.
INSTALLATION
Note the following items, and then install in the reverse order of removal.
CAUTION:
-
To prevent leakage of refrigerant, replace the O-ring with a new one. Apply a coat of compressor oil to the O-ring prior to installation.
-
Use a refrigerant collecting equipment (for HFO-1234yf) to charge the refrigerant. Refer to Charge Refrigerant.
-
Perform a check for refrigerant leakage when charging with refrigerant. Refer to Leak Test.
Other materials
How to switch the display
With the ignition switch in the ON position, the Nissan Armada Intelligent Around
View Monitor can be activated either by pressing the CAMERA/
button or by shifting the transmission into the R (Reverse) position.
Once activated, the Nissan Armada system automatically presents different split- ...
Rear
Exploded View
Brake tube
Brake hose
Lock plate
Union bolt
Copper washer
To front brake tube. Refer to Exploded View.
: vehicle front
: N·m (kg-m, ft-lb)
: N·m (kg-m, in- ...
Third Seat Lh Position Initialization
Description
Perform the third seat LH position initialization when the following conditions are performed. For details, refer to Work Procedure.
Replacing third seat control unit LH.
Replacing third seat LH.
Manual function and folding function of third seat LH does not operate normally.
Work Proce ...