Work Procedure
When replacing ADAS control unit 2, it is necessary to write MAC key to ADAS control unit 2. Write MAC key to ADAS control unit 2 according to "MAC Key writing" procedure of "CONSULT Operation Manual".
CAUTION:
During MAC key writing, maintain the following conditions:
-
Ignition switch ON
-
CONSULT is connected to internet
PERFORM MAC KEY WRITING
-
Ignition switch ON.
-
Select "MAC Key writing" on "Work Support" of "ICC/ADAS 2" using CONSULT.
-
Touch "Write".
>>
WORK END
Other materials
Evap Canister
Exploded View
Vent hose 1
Canister filter
Bracket 3
EVAP canister
Vent hose 2
Bracket 1
Vent hose 3
EVAP canister vent control valve
Clip
EVAP control system pressure sensor
Bracket 2
Vent hose 4
Clamp
To fuel tank. Refer to F ...
Precautions
Precautions for Removing Battery Terminal
When disconnecting the 12V battery terminal, turn off the ACC power before disconnecting the 12V battery terminal, observing “How to disconnect 12V battery terminal” described below.
NOTE:
Some ECUs operate for a certain fixed time even after ignit ...
Brake Pedal
Inspection and Adjustment
INSPECTIONBrake Pedal HeightCheck the height (H1) between the floor panel and the brake pedal upper surface. H1
: Refer to Brake Pedal.
CAUTION:
Remove the front floor carpet.Stop Lamp SwitchCheck the clearance (A) among the brake pedal lever and the stop lamp switch ...