NIARMADA Nissan Armada manuals & owner information
Nissan Armada owner resource

Manuals, service information and practical owner guidance.

Fast access to Nissan Armada manuals, operating instructions, maintenance references and technical information.

Browse manuals →
Nissan Armada manual library

Nissan Armada 2025-2026 Service and Repair Manual: Memory Storing

Nissan Armada 2025-2026 Service and Repair Manual / Body Interior / Automatic Drive Positioner / Memory Storing

Description

Always perform the memory storage when the driver seat control unit or steering column control module is replaced. The memory function will not operate normally if no memory storage is performed. For details, refer to Work Procedure.

Work Procedure

Memory Storage Procedure

Two positions for the seat, steering column, and door mirror can be stored for memory operation by following procedure.

NOTE:

Memory registration can be performed with no restrictions of the shift position, vehicle speed, and ignition switch position.

REGISTRATION METHOD

  1. Adjust seat, steering column, and door mirror position manually.

  2. Push set switch.

    NOTE:

    • Memory indicator for which driver seat position is already retained in memory is illuminated for 5 seconds.

    • Memory indicator for which driver seat position is not retained in memory is illuminated for 0.5 seconds.

  3. Push the memory switch (1 or 2) for at least 1 second within 5 seconds after pushing the set switch.

    NOTE:

    • When registration is performed correctly, the memory indicator blinks for 5 seconds and a buzzer sounds.

    • If memory is stored in the same memory switch, the previous memory will be deleted.

  4. Confirm the operation of each part with memory operation.

>>

WORK END

    Other materials

    Shift Position
    Inspection CHECK SHIFT BUTTON OPERATION When pressing each shift button of electric shift selector, check that each button is not twisted, stuck, or does not make noise and can be operated smoothly. After pressing each shift button, check that all buttons return to original positions without sti ...

    Additional Service When Replacing Transfer Control Unit
    Description When replacing transfer control unit, the following work is required. For the work procedure, refer to Work Procedure.WORK AFTER REPLACEMENT Unit parameter writing Initial calibration Work Procedure WRITING THE REQUIRED INFORMATION FOR CONTROL UNIT REPLACEMENT With CONSULT Ignitio ...

    Additional Service When Replacing Driving Video Recorder Control Module
    Work Procedure DRIVING VIDEO RECORDER CONTROL MODULE REPLACEMENT Replace driving video recorder control module. Refer to Removal and Installation. >> GO TO 2. WRITING OF VIN DATA TO DRIVING VIDEO RECORDER CONTROL MODULE With CONSULT Ignition switch ON and wait at least 5 seconds. Select ...