Description
This describes how to erase the mixture ratio self-learning value. For the actual procedure, follow the instructions in “Diagnosis Procedure�. (For details, refer to Work Procedure .)
Work Procedure
START
With CONSULT
-
Start engine and warm it up to normal operating temperature.
-
On CONSULT screen, select “ECM�>>“Work support�>>“Air fuel ratio learning value clear�.
-
Clear mixture ratio self-learning value by touching “CLEAR�.
With GST
-
Start engine and warm it up to normal operating temperature.
-
Ignition switch OFF.
-
Disconnect mass air flow sensor (bank 1) harness connector.
-
Restart engine and let it idle for at least 5 seconds.
-
Stop engine and reconnect mass air flow sensor (bank 1) harness connector.
-
Select Service $03 with GST. Make sure DTC P0102 is detected.
-
Select Service $04 with GST to erase the DTC P0102.
>>
END
Other materials
4wd Mode Does Not Change
Description
Vehicle does not enter 4-wheel drive mode even though 4WD warning turned to OFF.
Diagnosis Procedure
CHECK DTC OF TRANSFER CONTROL UNIT
With CONSULT
Ignition switch ON.
Perform self-diagnosis for “AWD/4WD�.
Is any DTC detected?
YES >>
Check DTC detected item. Refer to DT ...
Rear Lower Link and Coil Spring
Exploded View
Frame
Adjusting bolt
Eccentric disc
Rear lower link
Axle housing
Lower rubber seat
Coil spring
Upper rubber seat
Upper spring seat
: Always replace after every disassembly.
: N·m (kg-m, ft-lb)
Removal and Installation
REMOVALRemove tires. Refer t ...
Repairing High Strength Steel
High Strength Steel (HSS) and Ultra High Strength Steel (UHSS)
High strength steel and ultra high strength steel are used for body panels in order to reduce vehicle weight.Accordingly, precautions in repairing automotive bodies made of high strength steel are described below:UNDERBODY COMPONENT PART ...