Panic alarm does not operate when press the PANIC ALARM button of Intelligent Key.
Diagnosis Procedure
Diagnosis ProcedureSide Body
WARNING:
Work after hoodledge reinforcement and roof are removed.
Remove the lower side dash assembly (reusable) from the vehicle for easier installation.
Urethane foam : Weld the parts onto the back of the component part.
*: For spot welding of steel plate of tensile strength 980 MPa, observe the ...
Diagnosis Procedure
CHECK STEERING TILT MECHANISM
Check for the following.
Mechanism deformation or pinched foreign materials.
Interference with other parts because of poor installation.
Is the inspection result normal?
YES>>
GO TO 2.
NO>>
Repair or replace the malfunctioning parts.
CHECK TILT SWITCH
Che ...
Precautions for Removing Battery Terminal
NOTE:
NOTE:
NOTE:
The removal of 12V battery may cause a DTC detection error.
HOW TO DISCONNECT 12V BATTERY TERMINAL
Disconnect 12V battery terminal according to instruction described below.
Open the hood.
Turn ignition switch to the ON position.
Turn ignition switch to the OFF position with the d ...