Work Procedure
Description
When replace each camera, it is necessary to write the camera parameters using CONSULT.
Write to around view monitor control unit according to "Parameter writing" procedure of "CONSULT Operation Manual".
Work Procedure
PARAMETER WRITING
CONSULT
-
Ignition switch ON.
-
Select "Parameter writing" on "Work Support" of "AROUND VIEW MONITOR" using CONSULT.
>>
INSPECTION END
Other materials
Brake System Tools and Preparation
Commercial Service Tool
Tool name
Description
Flare nut torque wrench
a: 10 mm (0.39 in), 11 mm (0.43 in), 12 mm (0.47 in)
Installing brake piping
Brake caliper wrench
Return the piston (Front brake caliper)
Brake caliper wrench
Return the piston (Rear brake caliper)
Lu ...
Battery Current Sensor
Exploded View
Without ProPILOT ASSIST 2.1
Battery fix frame
Battery cover
Negative cable
Battery current sensor
12V battery
Battery fix rod
Battery fix rod clip
Battery tray
Battery positive terminal
Battery positive terminal cover
Battery terminal with fusible link ...
Additional Service When Replacing Side Radar
Work Procedure
Always perform the side radar configuration after replacing the side radar.SIDE RADAR CONFIGURATION
Perform saving vehicle internal information according to "Replace ECU" in CONSULT Operation Manual.
>>
GO TO 2.
SIDE RADAR ALIGNMENT
Perform the side radar alignment with CONSUL ...