NIARMADA Nissan Armada manuals & owner information
Nissan Armada owner resource

Manuals, service information and practical owner guidance.

Fast access to Nissan Armada manuals, operating instructions, maintenance references and technical information.

Browse manuals →
Nissan Armada manual library

Nissan Armada 2025-2026 Service and Repair Manual: Power Outlet. Usb Power Socket

Nissan Armada 2025-2026 Service and Repair Manual / Electrical & Power Control / Power Outlet. Usb Power Socket

Precautions

Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"

The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain types of collision.

Information necessary to service the system safely is included in the “SRS AIR BAG” and “SEAT BELT” of this Service Manual.

WARNING:

Always observe the following items for preventing accidental activation.

  • To avoid rendering the SRS inoperative, which could increase the risk of personal injury or death in the event of a collision that would result in air bag inflation, it is recommended that all maintenance and repair be performed by an authorized NISSAN/INFINITI dealer.

  • Improper repair, including incorrect removal and installation of the SRS, can lead to personal injury caused by unintentional activation of the system. For removal of Spiral Cable and Air Bag Module, see “SRS AIR BAG”.

  • Never use electrical test equipment on any circuit related to the SRS unless instructed to in this Service Manual. SRS wiring harnesses can be identified by yellow and/or orange harnesses or harness connectors.

PRECAUTIONS WHEN USING POWER TOOLS (AIR OR ELECTRIC) AND HAMMERS

WARNING:

Always observe the following items for preventing accidental activation.

  • When using air or electric power tools or hammers, always switch the ignition/power switch OFF, disconnect the 12V battery or batteries, and wait at least 3 minutes before performing any service.

Precautions for Removing Battery Terminal

  • When disconnecting the 12V battery terminal, turn off the ACC power before disconnecting the 12V battery terminal, observing “How to disconnect 12V battery terminal” described below.

    NOTE:

    Some ECUs operate for a certain fixed time even after ignition switch is turned OFF and ignition power supply is stopped. If the battery terminal is disconnected before ECU stops, accidental DTC detection or ECU data damage may occur.

  • For Nissan Armada vehicles with the 2-batteries, be sure to connect the main battery and the sub battery before turning ON the ignition switch.

    NOTE:

    If the ignition switch is turned ON with any one of the terminals of main battery and sub battery disconnected, then DTC may be detected.

  • After installing the 12V battery, always check "Self Diagnosis Result" of all ECUs and erase DTC.

    NOTE:

    The removal of 12V battery may cause a DTC detection error.

HOW TO DISCONNECT 12V BATTERY TERMINAL

Disconnect 12V battery terminal according to instruction described below.

  1. Open the hood.

  2. Turn ignition switch to the ON position.

  3. Turn ignition switch to the OFF position with the driver side door opened.

  4. Get out of the vehicle and close the driver side door.

  5. Wait at least 3 minutes.

    CAUTION:

    While waiting, never operate the vehicle such as locking, opening, and closing doors. Violation of this caution results in the activation of ACC power supply according to the Auto ACC function.

  6. Remove 12V battery terminal.

    CAUTION:

    After installing 12V battery, always check self-diagnosis results of all ECUs and erase DTC.

Usb Power Socket

Usb Power Socket (second Fr)

Removal and Installation

REMOVAL

Remove front center console rear finisher assembly. Refer to Removal and Installation.

Press the USB power socket fixing pawl from the back of the front center console rear finisher assembly to remove the USB power socket.

: Pawl

INSTALLATION

Note the following, and install in the reverse order of removal.

Align the cut outs of USB power socket and front center console rear finisher assembly.

: Cut out

Usb Power Socket (second Rr)

Removal and Installation

REMOVAL

Remove rear center tray assembly. Refer to Removal and Installation.

Press the USB power socket fixing pawl from the back of the rear center console box to remove the USB power socket.

: Pawl

INSTALLATION

Note the following, and install in the reverse order of removal.

Align the cut outs of USB power socket and rear center console box.

: Cut out

Usb Power Socket (third)

Removal and Installation

REMOVAL

Remove luggage side lower finisher. Refer to Removal and Installation.

Press the USB power socket fixing pawl from the back of the luggage side lower finisher to remove the USB power socket.

: Pawl

INSTALLATION

Note the following, and install in the reverse order of removal.

Align the cut outs of USB power socket and luggage side lower finisher.

: Cut out
    Other materials

    Electric power steering
    WARNING If the Nissan Armada engine is turned off while driving, power steering assist will be disabled, making the steering wheel significantly harder to operate. If the electric power steering warning light illuminates while the Nissan Armada engine is running, the steering assist will ...

    Input Oil Seal
    Exploded View Transfer assembly Input oil seal     : vehicle front : Always replace after every disassembly. : Apply transfer fluid. Removal and Installation WARNING: Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and ...

    Hood
    Exploded View Hood assembly Hood hinge RH Stud ball Hood stay RH Hood seal Hood bumper rubber 1 Hood bumper rubber 2 Radiator core seal Hood insulator Hood stay LH Hood hinge LH : Clip : Pawl : Body grease , : Indicates that the part is connected at poi ...