Symptom Table
LOW TIRE PRESSURE WARNING LAMP SYMPTOM CHART
| Diagnosis items |
Symptom (Ignition switch ON) | Low tire pressure warning lamp | Cause | Action |
|---|---|---|---|---|
|
Low tire pressure warning lamp |
The low tire pressure warning lamp illuminates for 1 second, then turns OFF. |
|
Wake-up operation for all tire pressure sensors at wheels is completed. | No system malfunctions |
| The low tire pressure warning lamp repeats blinking ON for 2 seconds and OFF for 0.2 seconds. |
|
The all tire pressure sensor is not activated. | Perform the ID registration for all tire pressure sensors at wheels. Refer to Description. | |
| The low tire pressure warning lamp blinks once. |
|
The front left tire pressure sensor is not activated. | Perform the ID registration for the tire pressure sensor at front left wheel. Refer to Description. | |
| The low tire pressure warning lamp repeats blinking twice. |
|
The front right tire pressure sensor is not activated. | Perform the ID registration for the tire pressure sensor at front right wheel. Refer to Description. | |
| The low tire pressure warning lamp repeats blinking for 3 times. |
|
The rear right tire pressure sensor is not activated. | Perform the ID registration for the tire pressure sensor at rear right wheel. Refer to Description. | |
| The low tire pressure warning lamp repeats blinking for 4 times. |
|
The rear left tire pressure sensor is not activated. | Perform the ID registration for the tire pressure sensor at rear left wheel. Refer to Description | |
| The low tire pressure warning lamp turns ON and stays illuminated. |
|
Low tire pressure | Check the tire pressure for all wheels and adjust to the specified value. Refer to TIRE AIR PRESSURE : Service Data. | |
| Low tire pressure warning lamp | The low tire pressure warning lamp repeats blinking at 0.5-second intervals for 1 minute, and then stays illuminated. |
|
The combination meter fuse is open or removed (or pulled out). | Check and install the combination meter fuse. If necessary, replace the fuse. |
| The BCM harness connector is removed. | Check the connection conditions of the BCM harness connector, and repair if necessary. | |||
| Tire Pressure Monitoring System (TPMS) malfunction. |
|
Other materials
How to enable/disable the I-BSI system
Example
ProPILOT Assist switch (design may vary depending on the Nissan Armada model)
Vehicle information display
Steering-wheel-mounted control (right side)
To configure the Nissan Armada Intelligent Blind Spot Intervention (I-BSI) system,
follow these steps:
1. Press the
butt ...
Fuel Level Sensor Unit, Fuel Filter and Fuel Pump Assembly
Exploded View
REMOVAL
Lock ring
Fuel level sensor unit, fuel filter and fuel pump assembly
Transfer tube bracket
Transfer tube
O-ring
: Always replace after every disassembly.
DISASSEMBLY
Fuel filter and fuel pump assembly
Fuel level sensor unit
...
Seat Reclining
Diagnosis Procedure
CHECK RECLINING MECHANISM
Check for the following.
Mechanism deformation or pinched foreign materials.
Interference with other parts because of poor installation.
Is the inspection result normal?
YES>>
GO TO 2.
NO>>
Repair or replace the malfunctioning parts.
...







