High pressure fuel system components are between high pressure fuel pump and fuel injector.
Always release fuel pressure and never start the engine when performing removal and installation.
When removing or installing parts without releasing fuel pressure, fuel may be splashed and, if fuel contacts skin or eyes, it may cause inflammation.
PRECAUTIONS FOR REMOVING BATTERY TERMINAL
PRECAUTIONS FOR SUPPLEMENTAL RESTRAINT SYSTEM (SRS) AIR BAG AND SEAT BELT PRE-TENSIONERRemoval and Installation
REMOVAL
Fully open front door.
Apply a protective tape (A) on the parts to protect it from damage.
Disengage fixing clips using a remover tool (A).
: Clip
Cut double-sided tape using a remover tool and cutter.
CAUTION:
Remove double-sided tape remaining on body side panel with a double-side ...
Exploded View
Radiator Condenser outlet pipe O-ring Condenser & liquid tank assembly Condenser seal Refrigerant pressure sensor Condenser inlet pipe : Pawl : Always replace after every disassembly. : N·m (kg-m, in-lb) , , : Indicates that the part is connected at points with same symbol in actual v ...
Steering Gear and Linkage
Item Standard
: Gear housing end
: Inner socket end Rack stroke neutral position (C) 27.5 mm (1.083 in) Rack stroke full stroke position (C) 154 mm (6.06 in) Outer socket ball joint Swing force* (Spring balance measurement) 14.0 – 40.6 N (1.43 – 4.14 kgf, 3.15 – 9.12 lbf) Ball joint ...