CAUTION:
Note the following precautions when disassembling and assembling drive shaft.
Joint sub-assembly does not disassemble because it is non-overhaul parts.
Perform work in a dust-free location.
Before disassembling and assembling, clean the parts.
Prevent the entry of foreign objects during disassembly of the service location.
Disassembled parts must be carefully reassembled in the correct order. If work is interrupted, a clean cover must be placed over parts.
Paper waste must be used. Fabric shop cloths must not be used because of the danger of lint adhering to parts.
Disassembled parts (except for rubber parts) should be cleaned with kerosene which shall be removed by blowing with air or wiping with paper waste.
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
Precaution for when Jacking and Lifting Up the Vehicle with Electronic Air Suspension
SystemWork Procedure
Always perform the front camera unit configuration after replacing the front camera unit.
Always perform the camera aiming after removing and installing or replacing the front camera unit.
CAUTION:
The system does not operate normally unless the front camera unit configuration and the camera aiming ...
Work Procedure
Description
Vehicle specification needs to be written with CONSULT because it is not written after replacing the display unit. For details the operation, refer to "CONSULT Operation Manual".
Work Procedure [Display Unit]
WRITING VEHICLE SPECIFICATION
With CONSULT
Perform writing vehicle specificat ...
Exploded View
INSTRUMENT PANEL ASSEMBLY
Front speaker grille*1 Display unit cover Display unit Instrument panel assembly Instrument mask LH Instrument finisher A Display unit finisher LH Instrument pad A Steering column cover upper Steering column cover lower Instrument lower panel LH Glove box lid in ...