AV COMMUNICATION SYSTEM
Solder the repaired parts, and wrap with tape. [Frays of twisted line must be within 110 mm (4.33 in).]

Do not perform bypass wire connections for the repair parts. (The spliced wire will become separated and the characteristics of twisted line will be lost.)

PRECAUTIONS FOR TROUBLE DIAGNOSIS : PrecautionsRemoval and Installation
REMOVAL
Remove the back door finisher. Refer to Removal and Installation.
Remove the rear camera mounting screws , then remove the rear camera .
INSTALLATION
Install in the reverse order of removal.
Perform parameter writing. (With ProPILOT Assist 2.1) Refer to Work Procedure.
Perform camera imag ...
Removal and Installation
REMOVAL
Remove instrument panel assembly. Refer to Removal and Installation.
Disconnect intake door motor harness connector .
Remove fixing screws , and then remove intake door motor.
INSTALLATION
Install in the reverse order of removal. ...
Removal and Installation
WARNING:
CAUTION:
Replace wheel hub and bearing assembly as an assembly when replacing because sensor rotor cannot be disassembled.
REMOVAL
Remove wheel hub and bearing assembly. Refer to the following.
2WD models: Refer to Removal and Installation.
4WD models: Refer to Removal and Installation.
IN ...