
NOTE:
NOTE:
NOTE:
The removal of 12V battery may cause a DTC detection error.
HOW TO DISCONNECT 12V BATTERY TERMINAL
Disconnect 12V battery terminal according to instruction described below.
Open the hood.
Turn ignition switch to the ON position.
Turn ignition switch to the OFF position with the driver side door opened.
Get out of the vehicle and close the driver side door.
| BR08DE | : 4 minutes | R9N engine | : 12 minutes |
| BR10DE | : 12 minutes | V9X engine | : 4 minutes |
| D4D engine | : 20 minutes | YD25DDTi | : 2 minutes |
| HR09DET | : 12 minutes | YS23DDT | : 4 minutes |
| HR10DDT | : 12 minutes | YS23DDTT | : 4 minutes |
| HR10DET | : 12 minutes | ZD30DDTi | : 60 seconds |
| HR13DDT | : 12 minutes | ZD30DDTT | : 60 seconds |
| HRA2DDT | : 12 minutes | K9K engine | : 4 minutes |
| M9R engine | : 4 minutes | R9M engine | : 4 minutes |
CAUTION:
Remove 12V battery terminal.
CAUTION:
Precautions
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"Grinding Power of Air Sander
The diameter (shown in the figure) of a circle traced by a part of the dual action sander and the orbital sander is called an orbit diameter. The larger the area shown with diagonal lines, the greater the grinding power is.
When surface accuracy is required, a sander with a smaller orbit diameter s ...
Exploded View
Back door weather-strip Back door hinge Back door stay* Back door stay upper bracket* Back door bumper rubber upper Back door stay lower bracket Back door bumper rubber lower Drain plug TORX bolt Back door striker Back door panel : Center mark : Seam : Matching mark : Pawl : Always re ...
Inspection
INSPECTION AFTER REMOVAL
Examine with eyes that there is no stain, clogging, or damage on air cleaner filter.
Remove dusts (such as dead leafs) on air cleaner filter surface and inside cleaner case.
To clean air cleaner element, blow it from intake manifold side towards air intake side to remove tra ...