
NOTE:
NOTE:
NOTE:
The removal of 12V battery may cause a DTC detection error.
HOW TO DISCONNECT 12V BATTERY TERMINAL
Disconnect 12V battery terminal according to instruction described below.
Open the hood.
Turn ignition switch to the ON position.
Turn ignition switch to the OFF position with the driver side door opened.
Get out of the vehicle and close the driver side door.
| BR08DE | : 4 minutes | R9N engine | : 12 minutes |
| BR10DE | : 12 minutes | V9X engine | : 4 minutes |
| D4D engine | : 20 minutes | YD25DDTi | : 2 minutes |
| HR09DET | : 12 minutes | YS23DDT | : 4 minutes |
| HR10DDT | : 12 minutes | YS23DDTT | : 4 minutes |
| HR10DET | : 12 minutes | ZD30DDTi | : 60 seconds |
| HR13DDT | : 12 minutes | ZD30DDTT | : 60 seconds |
| HRA2DDT | : 12 minutes | K9K engine | : 4 minutes |
| M9R engine | : 4 minutes | R9M engine | : 4 minutes |
CAUTION:
Remove 12V battery terminal.
CAUTION:
Precaution for when Jacking and Lifting Up the Vehicle with Electronic Air Suspension
SystemChanging
WARNING:
Recommended fluid and fluid capacity Refer to Fluids and Lubricants.
CAUTION:
Use only recommended A/T fluid. Never mix with other A/T fluid.
Start the engine.
Adjust the A/T fluid temperature to be approximately 50°C (122°F).
NOTE:
Check with “Fluid temperature” in “TRANSMISS ...
Work Procedure
Description
Vehicle specification needs to be written with CONSULT because it is not written after replacing the air suspension contorol module.
For details the operation, refer to “CONSULT Operation Manual”.
Work Procedure
WRITING VEHICLE SPECIFICATION AND VIN
With CONSULT
Perform writing vehic ...
WATER PUMP : Exploded View
Water pump Gasket : N·m (kg-m, ft-lb) : Always replace after every disassembly. ...