Nissan Armada 2025-2026 Service and Repair Manual: Changing
WARNING:
| Recommended fluid and fluid capacity | Refer to Fluids and Lubricants. |
CAUTION:
Use only recommended A/T fluid. Never mix with other A/T fluid.
Start the engine.
Adjust the A/T fluid temperature to be approximately 50°C (122°F).
NOTE:
Check with “Fluid temperature” in “TRANSMISSION” using CONSULT.
Stop the engine.
Lift up the vehicle.
| (1) | : Closed |
| (2) | : Slow drain |
| (3) | : Overflow |
| (4) | : Drain |
NOTE:
Install the A/T fluid injection plug (SST: NI-52972–1) and charge pipe adapter set (SST: NI-52584) to the overflow tube.
Install the drain plug and tighten it to the specified torque.
| Drain plug | : 6 N·m (0.61 kg-m, 53 in-lb) |
CAUTION:
Never overtighten the drain plug.
Lower the vehicle.
Start the engine and let it idle for 3 minutes.
Stop the engine.
Repeat steps 4 – 13 (one time).
Start the engine.
Adjust the A/T fluid temperature to be approximately 50°C (122°F).
NOTE:
Check that the “Fluid temperature” in “Data Monitor” is between 45°C (113°F) and 55°C (131°F) using CONSULT.
Lift up the vehicle.
| (1) | : Closed |
| (2) | : Slow drain |
| (3) | : Overflow |
| (4) | : Drain |
Insert OFT position change wrench (SST: NI-52972–2) into overflow tube and rotate to position (1) (Closed).
Install the drain plug and tighten it to the specified torque.
| Drain plug | : 6 N·m (0.61 kg-m, 53 in-lb) |
CAUTION:
Never over tighten the drain plug.
Never reuse O-ring.
Clear the deterioration level data of A/T fluid. (When the control valve & TCM has not been replaced.)
Select "Work Support" in "TRANSMISSION" using CONSULT.
Select "CONFIRM ATF DETERIORATION".
Touch "Start".
Touch "Clear".
Work end.
Refilling
WARNING:
Recommended fluid and fluid capacity Refer to Fluids and Lubricants.
CAUTION:
Use only recommended A/T fluid. Never mix with other A/T fluid.
Lift up the vehicle.
When the drain plug is ...
Adjustment
WARNING:
Recommended fluid and fluid capacity : Refer to Fluids and Lubricants.
CAUTION:
Use only recommended A/T fluid. Never mix with other A/T fluid.
Always maintain the A/T fluid temperature wi ...
Other materials:
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain types of collisions.
Information necessary to service the system safely is inclu ...
Removal and Installation
WARNING:
REMOVAL
WARNING:
CAUTION:
Never depress the brake pedal while removing the brake pads because the piston may pop out.
If the brake fluid or grease adheres to the brake caliper assembly and disc rotor, quickly wipe it off.
Remove tires. Refer to ROAD WHEEL TIRE : Removal & Installation. ...
Removal and Installation
WARNING:
REMOVAL
The ignition switch OFF.
CAUTION:
Wait for 60 seconds after the ignition switch OFF.
Disconnect negative battery terminal. Refer to Removal and Installation
Disconnect the transfer control actuator connector .
Remove harness clip .
Remove transfer control actuator mounting bolt ...
0.007