
NOTE:
NOTE:
NOTE:
The removal of 12V battery may cause a DTC detection error.
HOW TO DISCONNECT 12V BATTERY TERMINAL
Disconnect 12V battery terminal according to instruction described below.
Open the hood.
Turn ignition switch to the ON position.
Turn ignition switch to the OFF position with the driver side door opened.
Get out of the vehicle and close the driver side door.
| BR08DE | : 4 minutes | R9N engine | : 12 minutes |
| BR10DE | : 12 minutes | V9X engine | : 4 minutes |
| D4D engine | : 20 minutes | YD25DDTi | : 2 minutes |
| HR09DET | : 12 minutes | YS23DDT | : 4 minutes |
| HR10DDT | : 12 minutes | YS23DDTT | : 4 minutes |
| HR10DET | : 12 minutes | ZD30DDTi | : 60 seconds |
| HR13DDT | : 12 minutes | ZD30DDTT | : 60 seconds |
| HRA2DDT | : 12 minutes | K9K engine | : 4 minutes |
| M9R engine | : 4 minutes | R9M engine | : 4 minutes |
CAUTION:
Remove 12V battery terminal.
CAUTION:
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
Precaution for WorkDiagnosis Procedure
CHECK DTC OF TRANSFER CONTROL UNIT
With CONSULT
Ignition switch ON.
Perform self-diagnosis for “AWD/4WD”.
Is any DTC detected?
YES >>
Check DTC detected item. Refer to DTC Index.
NO>>
GO TO 2.
CHECK 4WD SHIFT INDICATOR
Check 4WD shift indicator function. Refer to Component Functio ...
LiquidGasket
LIQUID GASKET APPLICATION PROCEDURE
Remove old liquid gasket adhering to the liquid gasket application surface and the mating surface.
Remove liquid gasket completely from the liquid gasket application surface, mounting bolts, and bolt holes.
Wipe the liquid gasket application surface and the matin ...
Windshield wiper blades
Cleaning
Basic information
If visibility in your Nissan Armada is reduced after using the washer system,
or if the wiper blades produce chatter or streaking, contaminants such as wax, oil,
or dirt may be present on the windshield or blades.
Clean the windshield thoroughly using a suitable was ...