
NOTE:
NOTE:
NOTE:
The removal of 12V battery may cause a DTC detection error.
HOW TO DISCONNECT 12V BATTERY TERMINAL
Disconnect 12V battery terminal according to instruction described below.
Open the hood.
Turn ignition switch to the ON position.
Turn ignition switch to the OFF position with the driver side door opened.
Get out of the vehicle and close the driver side door.
| BR08DE | : 4 minutes | R9N engine | : 12 minutes |
| BR10DE | : 12 minutes | V9X engine | : 4 minutes |
| D4D engine | : 20 minutes | YD25DDTi | : 2 minutes |
| HR09DET | : 12 minutes | YS23DDT | : 4 minutes |
| HR10DDT | : 12 minutes | YS23DDTT | : 4 minutes |
| HR10DET | : 12 minutes | ZD30DDTi | : 60 seconds |
| HR13DDT | : 12 minutes | ZD30DDTT | : 60 seconds |
| HRA2DDT | : 12 minutes | K9K engine | : 4 minutes |
| M9R engine | : 4 minutes | R9M engine | : 4 minutes |
CAUTION:
Remove 12V battery terminal.
CAUTION:
PRECAUTIONS FOR SUPPLEMENTAL RESTRAINT SYSTEM (SRS) AIR BAG AND SEAT BELT PRE-TENSIONER
: Precautions
PRECAUTIONS FOR TROUBLE DIAGNOSIS : PrecautionsDiagnosis Procedure
CHECK AUTO ANTI-DAZZLING INSIDE MIRROR POWER SUPPLY AND GROUND CIRCUIT
Check auto anti-dazzling inside mirror power supply and ground circuit. Refer to Diagnosis Procedure.
Is the inspection result normal?
YES>>
GO TO 2.
NO>>
Repair or replace the malfunctioning parts.
CHECK AUTO ANTI- ...
Removal and Installation
REMOVAL
Remove rear bumper energy absorber. Refer to Removal and Installation.
Remove harness clip .
Disconnect outside key antenna (rear bumper) harness connector.
Remove outside key antenna (rear bumper) fixing nuts , and then remove outside key antenna (rear bumper) .
INSTALLATION
Install in th ...
Exploded View
Rear door panel Inside seal Rear door sash inner cover Pull handle cap Inside handle cap Rear door finisher Pull handle bracket Grommet : Clip : Pawl : N·m (kg-m, in-lb) ...