Maintenance
Special Service ToolRemoval and Installation
REMOVAL
Remove headlining assembly. Refer to Removal and Installation.
Disconnect IR sensor harness connector .
Remove room lamp harness from IR sensor assembly.
Disengage fixing pawls, and then remove IR sensor finisher and IR sensor assembly .
: Pawl
INSTALLATION
Install in the reverse o ...
Symptom Table
WARNING:
Perform self-diagnosis using CONSULT before the symptom diagnosis. Perform trouble diagnosis if any DTC is detected. Refer to DTC Index.
SymptomPossible causeHow to solveVehicle height is not risen/fallenEngine is stoppedStart the engine.Each switch is OFFCheck the staus of the switch.Elect ...
Removal and Installation
WARNING:
REMOVAL
Remove transfer assembly from vehicle. Refer to Removal and Installation.
Remove input oil seal.
CAUTION:
Never damage the front case and input shaft.
INSTALLATION
Note the following, and install in the reverse order of removal.
L : 1.5 – 2.5 mm (0.059 – 0.098 in)
CAUTION: ...