Nissan Armada owner resource

Manuals, service information and practical owner guidance.

Fast access to Nissan Armada owner manuals, service procedures, maintenance references, technical information and practical guides for different Armada generations.

Browse manuals →
Nissan Armada manual library

Nissan Armada 2025-2026 Service and Repair Manual: Rear Differential Gear Oil

Inspection

WARNING:

  • Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air suspension component parts. Refer to Precaution for when Jacking and Lifting Up the vehicle with Electronic Air Suspension System.

OIL LEAKAGE

Make sure that oil is not leaking from final drive assembly or around it.

OIL LEVEL

Check oil level from filler plug mounting hole as shown in the figure after removing filler plug and gasket from final drive assembly.

CAUTION:

The ignition switch OFF while checking oil level.

  • Oil level should be level with bottom of filler plug hole. Add gear oil if necessary. Refer to Refilling.

Set a gasket on filler plug and install it on final drive assembly.

CAUTION:

Never reuse gasket.

Tighten filler plug to the specified torque. Refer to Exploded View.

Draining

WARNING:

  • Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air suspension component parts. Refer to Precaution for when Jacking and Lifting Up the vehicle with Electronic Air Suspension System.

The ignition switch OFF.

Remove drain plug and gasket.

Drain gear oil.

Set a gasket on drain plug and install it to final drive assembly.

CAUTION:

Never reuse gasket.

Tighten drain plug to the specified torque. Refer to Exploded View.

Refilling

WARNING:

  • Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air suspension component parts. Refer to Precaution for when Jacking and Lifting Up the vehicle with Electronic Air Suspension System.

Remove filler plug and gasket. Then fill with new gear oil until oil level reaches the specified level near filler plug mounting hole.

Recommended oil and capacity Refer to Fluids and Lubricants.

Set a gasket on filler plug and install it on final drive assembly.

CAUTION:

Never reuse gasket.

Tighten filler plug to the specified torque. Refer to Exploded View.

    Other materials

    Front Cover
    Exploded View Front cover Dowel pin Oil pressure sensor Oil temperature sensor Crankshaft pulley bolt Crankshaft pulley Front oil seal O-ring(oil line) O-ring(water line) Comply with the installation procedure when tightening. Refer to Removal & Installation. &n ...

    Transfer Cam Position Sensor
    Exploded View Transfer assembly Transfer cam position sensor     : N·m (kg-m, in-lb)         Removal and Installation WARNING: Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air suspe ...

    Diagnosis and Repair Workflow
    Work Flow DETAILED FLOWINTERVIEW FROM THE CUSTOMER Clarify customer complaints before inspection. First of all, perform an interview utilizing Diagnostic Work Sheet and reproduce the symptom as well as fully understand it. Ask customer about his/her complaints carefully. Check symptoms by driving ve ...