Nissan Armada owner resource

Manuals, service information and practical owner guidance.

Fast access to Nissan Armada manuals, operating instructions, maintenance references and technical information.

Browse manuals
Nissan Armada manual library

Nissan Armada 2025-2026 Service and Repair Manual: Rear Differential Gear Oil: R240

Inspection

WARNING:

  • Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air suspension component parts. Refer to Precaution for when Jacking and Lifting Up the vehicle with Electronic Air Suspension System.

OIL LEAKAGE

Make sure that oil is not leaking from final drive assembly or around it.

OIL LEVEL

Check oil level from filler plug mounting hole as shown in the figure after removing filler plug and gasket from final drive assembly.

CAUTION:

The ignition switch OFF while checking oil level.

  • Oil level should be level with bottom of filler plug hole. Add gear oil if necessary. Refer to Refilling.

Set a gasket on filler plug and install it on final drive assembly.

CAUTION:

Never reuse gasket.

Tighten filler plug to the specified torque. Refer to Exploded View.

Draining

WARNING:

  • Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air suspension component parts. Refer to Precaution for when Jacking and Lifting Up the vehicle with Electronic Air Suspension System.

The ignition switch OFF.

Remove drain plug and gasket.

Drain gear oil.

Set a gasket on drain plug and install it to final drive assembly.

CAUTION:

Never reuse gasket.

Tighten drain plug to the specified torque. Refer to Exploded View.

Refilling

WARNING:

  • Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air suspension component parts. Refer to Precaution for when Jacking and Lifting Up the vehicle with Electronic Air Suspension System.

Remove filler plug and gasket. Then fill with new gear oil until oil level reaches the specified level near filler plug mounting hole.

Recommended oil and capacity Refer to Fluids and Lubricants.

Set a gasket on filler plug and install it on final drive assembly.

CAUTION:

Never reuse gasket.

Tighten filler plug to the specified torque. Refer to Exploded View.

    Other materials

    Steering System Tools and Preparation
    Special Service Tools The actual shape of the tools may differ from those illustrated here. Tool number (TechMate No.) Tool name Description  —  (NI-44372) Pull gauge Measuring steering wheel turning force and ball joint swinging force KV40107300 (NI-51751) Boot band crimping tool ...

    Insufficient Cooling
    Front Air Conditioner Description Symptom Insufficient cooling No cool air comes out. (Air flow volume is normal.) Diagnosis Procedure NOTE: Perform self-diagnoses with CONSULT before performing symptom diagnosis. If any DTC is detected, perform the corresponding diagnosis.CHECK MAGNET CLUTCH ...

    System Initialization
    Description Initialization of system should be conducted after the following conditions. Refer to Work Procedure. When the moonroof motor assembly or sunshade motor assembly is replaced. When the moonroof or sunshade does not operate normally. (Incomplete initialization conditions) Work Procedu ...