Disc Rotor
Inspection
WARNING:
-
Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air suspension component parts. Refer to Precaution for when Jacking and Lifting Up the vehicle with Electronic Air Suspension System.
INSPECTION
Uneven wear
Check the uneven wear of the disc rotor using a micrometer. Replace the disc rotor if the thickness is below the wear limit. Refer to Removal and Installation.
| Thickness variation (measured at 8 positions) | : Refer to Rear Disc Brake. |
Other materials
Rear Axle Service Data and Specifications
Wheel Bearing
Item Standard
Axial end play
0.05 mm (0.002 in) or less
Drive Shaft
With differential lock Item Standard
Grease quantity
Wheel side
155 - 175 g (5.47 – 6.17 oz)
Final drive side
310 - 330 g (10.94 – 11.63 oz)
Boots installed length
Wheel side
143.6 mm (5 ...
Electronic Air Suspension System
Work Support
For each work support, follow the procedure shown in CONSULT.The table below shows the additional explanations provided in the CONSULT.CAUTION:
At the end of the work, be sure to perform a “Vehicle height adjustment” and adjust the vehicle to NORMAL height before returning it to the ...
Precautions
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger fo ...