NIARMADA Nissan Armada manuals & owner information
Nissan Armada owner resource

Manuals, service information and practical owner guidance.

Fast access to Nissan Armada manuals, operating instructions, maintenance references and technical information.

Browse manuals →
Nissan Armada manual library

Nissan Armada 2025-2026 Service and Repair Manual: Input Oil Seal

Nissan Armada 2025-2026 Service and Repair Manual / Transmission & Driveline / Driveline. Transfer: Atx93a / Input Oil Seal

Exploded View

Transfer assembly Input oil seal    
: vehicle front
: Always replace after every disassembly.
: Apply transfer fluid.

Removal and Installation

WARNING:

  • Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air suspension component parts. Refer to Precaution for when Jacking and Lifting Up the vehicle with Electronic Air Suspension System.

REMOVAL

Remove transfer assembly from vehicle. Refer to Removal and Installation.

Remove input oil seal.

CAUTION:

Never damage the front case and input shaft.

INSTALLATION

Note the following, and install in the reverse order of removal.

  • Install input oil seal with a drift (A) (commercial service tool) within the dimension (L) shown as follows.

    L : 1.5 – 2.5 mm (0.059 – 0.098 in)

    CAUTION:

    • Never reuse input oil seal.

    • Apply transfer fluid onto circumference of oil seal.

    • When installing, never incline input oil seal.

    • Never handle the oil seal inner periphery and oil seal lip.

    Other materials

    Resetting the seat positions
    Basic information The Nissan Armada is equipped with a memory system for 3rd row power seats, allowing them to retain their original positions. However, under certain conditions such as power interruption, the stored position may be lost and require recalibration. WARNING During the reset pro ...

    Additional Service When Replacing Electrical Brake Control Unit
    Work Procedure DescriptionWhen replacing the electrical brake control unit, the procedures of AFTER REPLACEMENT must be performed.CAUTION: If the electrical brake control unit is undamaged, do not decide to replace it based on DTC detected in the past.AFTER REPLACEMENTAfter replacing the electrical ...

    Configuration
    Description Vehicle specification needs to be written with CONSULT because it is not written after replacing the ABS actuator and electric unit (control unit).The configuration requires network connection. CONSULT connects to network and then it downloads the configuration data from the server. Then ...