Exploded View

![]() |
Rear height sensor | ||||
| :vehicle front | |||||
![]() |
:N·m (kg-m, ft-lb) | ||||
![]() |
:N·m (kg-m, in-lb) | ||||
Removal and Installation
REMOVAL
WARNING:
-
When removing the air suspension component parts, always follow the removing procedure since the vehicle height may accidentally drop and it can lead to personal injury.
CAUTION:
-
Never disassemble the rear height sensor.
Start engine.
Turn auto height mode control switch to ON, shift the shift position to N and set to normal height.
Turn OFF the electronic air suspension function. Refer to Operation.
Stop engine.
Lift up the vehicle.
Disconnect rear height sensor harness connector.
Remove rear height sensor.
INSTALLATION
Note the following, and install in the reverse order of the removal.
-
Completely engage hooks on frame when installing rear height sensor.

-
Perform inspection after installation. Refer to Inspection.
-
Perform adjustment after installation. Refer to Adjustment.
Inspection
INSPECTION AFTER INSTALLATION
-
Make sure the electronic air suspension function is turn ON. Refer to Operation.
-
Confirm that no warning message is displayed on the information display. Refer to Air suspension warning.
-
Perform the self-diagnosis using CONSULT. Check if any DTC is detected. Refer to CONSULT Function.
-
Confirm to close the hood.
Adjustment
ADJUSTMENT AFTER INSTALLATION
Perform the height sensor calibration. Refer to Work Support.
Other materials
How to park with predictive course lines
WARNING
If non-standard tire sizes are installed on the Nissan Armada, the predictive
course lines may not display accurately.
On slippery or snow-covered roads, the Nissan Armada predicted path may
differ from the actual vehicle movement.
If the Nissan Armada battery is disconnected o ...
Side Oil Seal
Exploded View
Rear final drive assembly
Side oil seal
: vehicle front
: Always replace after every disassembly.
Removal and Installation
WARNING:
Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air su ...
Telematics Antenna
Removal & Installation
REMOVALRemove the instrument panel assembly. Refer to Removal and Installation.
Remove the screw and clips to remove the telematics antenna .
: Clips
INSTALLATIONInstall in the reverse order of removal.
Feeder Layout
Telematics antenna
TCU
: Crip
...


