NIARMADA Nissan Armada manuals & owner information
Nissan Armada owner resource

Manuals, service information and practical owner guidance.

Fast access to Nissan Armada owner manuals, service procedures, maintenance references, technical information and practical guides for different Armada generations.

Browse manuals →
Nissan Armada manual library

Nissan Armada 2025-2026 Service and Repair Manual: Rear Propeller Shaft: 3f C-C-C

Nissan Armada 2025-2026 Service and Repair Manual / Maintenance. Maintenance Procedures / Chassis Maintenance / Rear Propeller Shaft: 3f C-C-C

Inspection

WARNING:

  • Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air suspension component parts. Refer to Precaution for when Jacking and Lifting Up the vehicle with Electronic Air Suspension System.

LOOSENESS OF CONNECTED PART

Check each fixing bolt and nut for looseness using torque wrench. For each tightening torque, refer to Exploded View.

BACKLASH OF JOINT PART

Move the joint of propeller shaft up and down and from side to side (axial direction of shaft and right angle to shaft) to check that the joint has no backlash extremely. If the joint has a malfunction, remove propeller shaft and perform inspection.

BACKLASH OF CENTER BEARING

Move the shaft near center bearing up and down and from side to side (axial direction of shaft and right angle to shaft) to check that the bearing has no backlash. If the bearing has a malfunction, remove propeller shaft and perform inspection.

APPEARANCE AND NOISE

  • Check propeller shaft tube surface for dents or cracks. If malfunction is detected, replace propeller shaft assembly.

  • If center bearing is noisy or damaged, replace propeller shaft assembly.

VIBRATION

If vibration is present at high speed, adjust the propeller shaft phase first.

Check the propeller shaft for bend and damage. If damaged, replace propeller shaft assembly.

Perform a cruise test drive to check the propeller shaft for runout. If vibration occurs, separate propeller shaft at final drive companion flange; then change the phase between companion flange and propeller shaft by the one bolt hole at a time and install propeller shaft.

If vibration is still detected, measure propeller shaft runout after removing it. Refer to Inspection.

    Other materials

    System temporarily unavailable
    While operating the Nissan Armada, certain road environments such as winding mountain routes, steep inclines, sharp curves, narrow lanes, or areas under construction can temporarily affect the performance of the driver assistance systems. In these situations, the sensors may incorrectly id ...

    Capacities and recommended fluids/ lubricants
    Basic information The values listed below represent approximate service capacities for the Nissan Armada and are intended as a general reference for maintenance planning. Actual refill quantities for your Nissan Armada may vary slightly depending on operating conditions and servicing procedu ...

    Distance Sensor Alignment
    Work Procedure Always perform the radar alignment after removing and installing or replacing the distance sensor. Application Notice Type Description TYPE 1 When using KV99112700 for radar alignment. Refer to Description. TYPE 2 When using 1-20-2851-1 for radar alignment. Refer to Descript ...