Inspection
WARNING:
-
Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air suspension component parts. Refer to Precaution for when Jacking and Lifting Up the vehicle with Electronic Air Suspension System.
MOUNTING INSPECTION
Check the mounting conditions (looseness, back lash) of each component and component conditions (wear, damage) are normal.
WHEEL BEARING INSPECTION
-
Move wheel hub and bearing assembly in the axial direction by hand. Check there is no looseness of wheel hub and bearing assembly.
Axial end play : Wheel Bearing -
Rotate wheel hub and bearing assembly, and check there is no unusual noise or other irregular conditions. If there is any of irregular conditions, replace wheel hub and bearing assembly.
Other materials
How to enable/disable the I-LI system
Example
ProPILOT Assist switch
Vehicle information display
Steering-wheel-mounted control (right side)
Basic information
In the Nissan Armada, the Intelligent Lane Intervention (I-LI) system can be
configured through the vehicle information display and steering wheel controls,
pr ...
Wastegate Valve Closed Position Learning
Description
Wastegate valve closed position learning is a function of ECM to learn the fully closed position of the wastegate valve by monitoring the wastegate valve position sensor output signal. It must be performed under any of the following conditions.
Work Procedure
PERFORM WASTEGATE VALVE CLOS ...
Side Camera
Removal and Installation
REMOVAL
Remove the door mirror finisher. Refer to Disassembly and Assembly.
Remove the side camera mounting screw , and then remove the side camera .
INSTALLATIONInstall in the reverse order of removal.
Perform parameter writing. (With ProPILOT Assist 2.1) Refer to Work ...