Removal and Installation
REMOVAL
Remove rear A/C unit assembly. Refer to Removal and Installation.
Remove rear in-vehicle sensor harness connector from rear A/C unit case LH.
Remove fixing screw 
, and then remove rear in-vehicle sensor.
INSTALLATION
Install in the reverse order of removal.
Other materials
Fuel Filler Lid
Removal and Installation
REMOVAL Fully open fuel filler base assembly.
Disengage fuel filler lid fixing pawl using a removal tool (A), and then remove fuel filler lid according to numerical order 1→2 indicated by arrows as shown in figure.
: Pawl
INSTALLATION Note the following items, and ...
Additional Service When Replacing Driving Video Recorder Control Module
Work Procedure
DRIVING VIDEO RECORDER CONTROL MODULE REPLACEMENT
Replace driving video recorder control module. Refer to Removal and Installation.
>>
GO TO 2.
WRITING OF VIN DATA TO DRIVING VIDEO RECORDER CONTROL MODULE
With CONSULT
Ignition switch ON and wait at least 5 seconds.
Select ...
Reservoir Tank Cap
Inspection
Check valve seat of reservoir tank cap.
: Metal plunger
Check if valve seat is swollen to the extent that the edge of the metal plunger cannot be seen when watching it vertically from the top.
Check if valve seat has no soil and damage.
Pull negative-pressure valve to ...