Removal & Installation
REMOVAL
Remove transmission assembly, refer to the following:
-
2WD models: Refer to Removal and Installation.
-
4WD models: Refer to Removal and Installation.
Remove drive plate. Refer to Removal and Installation.
Remove rear oil seal with a suitable tool.
CAUTION:
Be careful not to damage crankshaft and cylinder block.
INSTALLATION
Install rear oil seal.
-
Install rear oil seal so that each seal lip is oriented as shown in the figure.
 |
: Oil seal lip |
 |
: Dust seal lip |
| : Engine inside | |
 |
: Engine outside |
-
Press in rear oil seal (1) to the position as shown in the figure.
|
: Cylinder block rear end face |
 |
: 0 - 0.5 mm (0 - 0.020 in) |
-
Using a suitable drift (A), press-fit until the height of rear oil seal is level with the mounting surface.
-
Suitable drift: outer diameter 100 mm (3.94 in), inner diameter 85 mm (3.35 in).
CAUTION:
-
Be careful not to damage crankshaft and cylinder block.
-
Press-fit straight and avoid causing burrs or tilting oil seal.
-
-
Install in the reverse order of removal after this step.
Other materials
Safety information
WARNING
Always stop the Nissan Armada in a safe place and engage the parking
brake before operating the system. Using the system while driving can distract
the driver and increase the risk of accidents.
Maintain full attention on driving at all times. If the Nissan Armada
system respo ...
Engine Oil
Inspection
WARNING:
Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air suspension component parts. Refer to Precaution for when Jacking and Lifting Up the vehicle with Electronic Air Suspension System.
ENGINE OIL LEVELNOTE ...
Automatic Back Door Switch
Removal and Installation
REMOVALRemove instrument pad A. Refer to Removal and Installation.
Remove switch bracket fixing screws , and then remove switch bracket .
Disengage automatic back door switch fixing pawls using a remover tool (A), and then remove automatic back door switch from the switch ...