Nissan Armada 2025-2026 Service and Repair Manual: Removal and Installation
WARNING:
REMOVAL
Disconnect negative battery terminal. Refer to Removal and Installation.
Remove rear propeller shaft. Refer to Removal and Installation .
Remove front propeller shaft. Refer to Removal and Installation.
Disconnect transfer cam position sensor harness connectors and separate harnesses from transfer assembly.
Remove transfer breather hose. Refer to Removal and Installation.
Remove main muffler. Refer to EXHAUST SYSTEM : Removal & Installation.
Support transfer assembly and transmission assembly with a jack.
CAUTION:
Secure transfer assembly and transmission assembly to a jack.
Remove rear engine mounting cross member. Refer to Removal and Installation.
Remove transfer mounting bolts and separate transfer from transmission.
CAUTION:
Secure transfer assembly and transmission assembly to a jack.
INSTALLATION
Install in the reverse order of removal.
Exploded View
Transfer assembly : N·m (kg-m, ft-lb) ...
Inspection and Adjustment
INSPECTION AFTER INSTALLATION
Check fluid leakage and the fluid level. Refer to Inspection.
ADJUSTMENT AFTER INSTALLATION ...
Other materials:
Removal and Installation
WARNING:
Always observe the following items for preventing accidental activation.
Before disconnecting the air bag diagnosis sensor unit harness connector, be sure to disconnect each harness connector of the air bag modules, seat belt pre-tensioners and lap pre-tensioner to prevent air bag deploymen ...
Work Procedure
CAUTION:
Make sure to use CONSULT when performing stroke sensor calibration. (It cannot be performed by any means other than CONSULT.)
VEHICLE CONDITION
Stop the vehicle.
Turn the ignition switch OFF and disconnect CONSULT from data link connector.
>>
GO TO 2.
CHECK 12V BATTERY
Check the 12 ...
PRECAUTIONS FOR REMOVING BATTERY TERMINAL : Precautions
NOTE:
NOTE:
NOTE:
The removal of 12V battery may cause a DTC detection error.
HOW TO DISCONNECT 12V BATTERY TERMINAL
Disconnect 12V battery terminal according to instruction described below.
Open the hood.
Turn ignition switch to the ON position.
Turn ignition switch to the OFF position with the d ...
0.0052