Nissan Armada 2025-2026 Service and Repair Manual: Removal and Installation
WARNING:
REMOVAL
Put matching mark 
on rear propeller shaft flange yoke and final drive companion flange.
CAUTION:
Remove propeller shaft assembly fixing bolts and nuts.
Remove propeller shaft assembly from vehicle.
CAUTION:
Never damage rear oil seal of transfer.
Perform inspection after removal. Refer to Inspection.
INSTALLATION
Note the following, and install in the reverse order of removal.
For non-reusable parts, refer to Exploded View.
For each tightening torque, refer to Exploded View.
Never damage the rear oil seal lip when install rear propeller shaft to transfer.
If propeller shaft assembly or final drive assembly has been replaced, connect them as follows:
NOTE:Matching mark
is has been painted in either position.
Perform inspection after installation. Refer to Inspection.
Exploded View
REMOVAL
Propeller shaft assembly
: Vehicle front : N·m (kg-m, ft-lb) : Always replace after every disassembly.
DISASSEMBLY
Snap ring Journal bearing Journal Sleeve yoke Propeller shaft tube ...
Disassembly and Assembly
DISASSEMBLY
Put a matching mark between propeller shaft and flange yoke as shown.
CAUTION:
For matching mark, use paint. Never damage the surface.
Remove snap rings .
Lightly tap bottom of yoke us ...
Other materials:
Precautions for Removing Battery Terminal
NOTE:
NOTE:
NOTE:
The removal of 12V battery may cause a DTC detection error.
HOW TO DISCONNECT 12V BATTERY TERMINAL
Disconnect 12V battery terminal according to instruction described below.
Open the hood.
Turn ignition switch to the ON position.
Turn ignition switch to the OFF position with the d ...
Removal & Installation
REMOVAL
Remove the instrument panel assembly. Refer to Removal and Installation.
Remove the screw and clips to remove the telematics antenna .
: Clips
INSTALLATION
Install in the reverse order of removal. ...
Removal and Installation
CAUTION:
When removing and installing 12V Battery, because of the heavy battery, please be careful about the working posture and use the ladder as required.
After the battery of a vehicle equipped with the Stop/Start System is replaced, the cumulative battery discharge current value stored in IPDM ...
0.0065