Nissan Armada 2025-2026 Service and Repair Manual: Removal and Installation
REMOVAL
WARNING:
CAUTION:
Never disassemble the rear height sensor.
Start engine.
Turn OFF the electronic air suspension function. Refer to Operation.
Stop engine.
Lift up the vehicle.
Disconnect rear height sensor harness connector.
Remove rear height sensor.
INSTALLATION
Note the following, and install in the reverse order of the removal.
Completely engage hooks on frame when installing rear height sensor.
Perform inspection after installation. Refer to Inspection.
Perform adjustment after installation. Refer to Adjustment.
Exploded View
Rear height sensor :Vehicle front :N·m (kg-m, ft-lb) :N·m (kg-m, in-lb) ...
Inspection
INSPECTION AFTER INSTALLATION
Confirm to close the hood.
...
Other materials:
Normal Operating Condition
SHIPPING MODE
Shipping mode inhibits battery power consumption during transportation or storage of the vehicle. Vehicle is set to shipping mode before being shipped from the factory.
When ignition switch is OFF, BCM operates shipping mode.
For shipping mode cancel operation, refer to Work Procedure. ...
Adjustment
PREPARATION BEFORE ADJUSTING
NOTE:
For details, refer to the regulations in your own country.
Perform aiming if the vehicle front body has been repaired and/or the headlamp assembly has been replaced.
Before performing aiming adjustment, check the following.
Adjust the tire pressure to the specific ...
Removal and Installation
WARNING:
REMOVAL
WARNING:
Never get burn yourself, as engine oil and engine coolant may be hot.
Remove engine under cover, using a power tool (commercial service tool). Refer to Removal and Installation.
Drain engine oil. Refer to Draining.
Disconnect A/T fluid cooler hose and oil cooler hose 2 .
...
0.009