Removal and Installation
REMOVAL
Remove front seatback trim and pad. Refer to Disassembly and Assembly.
Disengage fixing pawls and then remove front seatback blower motor.

![]() |
: Pawl |
Disengage front seatback blower motor harness fixing clip.
Disconnect front seatback blower motor connector and then remove front seatback blower motor from the front seat.
INSTALLATION
Install in the reverse order of removal.
Other materials
Front Heated Seat System
Symptom Table
Symptom Possible causeInspection item
Front heated seat system does not operate
Only the display unit operation does not operate
Check AV system
Display unit and multifunction switch operation does not operate
Fuse
Front seat heater power supply/ground/LIN signal circuit
Front seat ...
Moonroof Does Not Operate Properly
Description
Moonroof does not operate normally.
Moonroof Tilt UP/DOWN, OPEN/CLOSE does not operate.
Moonroof Tilt UP/DOWN, OPEN/CLOSE operation is slow.
Judder occurs during OPEN/CLOSE operation of moonroof.
Diagnosis Procedure
CHECK MOONROOF UNIT ASSEMBLY
Check the following items.
Damage, ...
Normal Operating Condition
Description
FRONT WIPER MOTOR PROTECTION FUNCTION
The CPU integrated in the front wiper motor may stop the front wiper to protect the front wiper motor if any obstruction (operation resistance) such as a large amount of snow is detected during the front wiper operation.
At that time turn OFF the ...
