Removal and Installation
REMOVAL
Remove front seat cushion trim and pad. Refer to Disassembly and Assembly.
Disengage fixing pawls and then remove front seat cushion blower motor.
 |
: Pawl |
Disengage front seat cushion blower motor harness fixing clip.
Disconnect front seat cushion blower motor connector and then remove front seat cushion blower motor from the front seat.
INSTALLATION
Install in the reverse order of removal.
Other materials
Front Oil Seal
Exploded View
Front output shaft
Front oil seal
Front case
Snap ring
Sprockets with chain
Snap ring
Rear case
Rear companion flange
O-ring
: Always replace after every disassembly.
: N·m (kg-m, ft-lb)
: Apply transfer fluid.
: Apply Genuine Liquid Gas ...
Additional Service When Replacing Power Steering Control Module Control Unit
Work Procedure
DESCRIPTIONWhen replacing the power steering control module, the procedures of AFTER REPLACEMENT must be performed.AFTER REPLACEMENTAfter replacing the power steering control module, the following items must be performed:
Power steering control module programming.
Power steering co ...
Mac Key Writing
Work Procedure
When replacing ADAS control unit 2, it is necessary to write MAC key to ADAS control unit 2. Write MAC key to ADAS control unit 2 according to "MAC Key writing" procedure of "CONSULT Operation Manual".CAUTION:
During MAC key writing, maintain the following conditions:
Ignition switc ...