Removal and Installation
REMOVAL
Captain Seat
Remove inside seat cushion finisher outer. Refer to Disassembly and Assembly.
Disconnect seat belt buckle harness connector and disengage harness clips.
Remove seat belt buckle mounting anchor bolt, and then remove seat belt buckle.
Bench Seat
Remove the following part.
-
Seat cushion trim and pad as a set (seat belt buckle LH): Refer to Disassembly and Assembly.
-
Inside seat cushion finisher outer (seat belt buckle RH): Refer to Disassembly and Assembly.
-
Inside seat cushion finisher outer (center seat belt buckle): Refer to Disassembly and Assembly.
Disconnect seat belt buckle harness connector and disengage harness clips.
Remove seat belt buckle mounting anchor bolt, and then remove seat belt buckle.
INSTALLATION
Install in the reverse order of removal.
Inspection
AFTER A COLLISION
WARNING:
To avoid the risk of death or severe injury:
-
Inspect all seat belt system components including the seat belt webbing, retractors, pretensioners, buckles, anchors, and attaching hardware after any collision.
-
Inspect all seat belt assemblies and components including webbing, retractors, buckles, anchors and attaching hardware not in use during a collision. Replace if either damage or improper operation is noted.
-
Failure to follow any of the above steps could result in serious personal injury in an accident.
Replace any seat belt assembly (including anchor bolts) if:
-
The seat belt is in use at the time of a collision (except for minor collisions and the belts, retractors and buckles show no damage and continue to operate properly).
-
The seat belt is damaged in an accident (i.e. torn webbing, bent retractor or guide, etc.).
-
The seat belt attaching point is damaged in an accident. Inspect the seat belt attaching area for damage or distortion and repair if necessary before installing a new seat belt assembly.
-
Anchor bolts are deformed or worn out.
-
The seat belt assembly must be replaced even if the seat belts were not in use during the collision in which the air bags were deployed.
PRELIMINARY CHECKS
Check the seat belt warning lamp for proper operation. Refer to Seat Belt Warning Lamp.
If the air bag warning lamp turns ON, perform self-diagnosis using CONSULT. Refer to CONSULT Function.
Check that the seat belt retractor, seat belt anchor and buckle bolts are tightened firmly.
Repeat steps above if necessary to check the other seat belts.
Other materials
Difference between predictive and actual distances
Basic information
The Nissan Armada RearView Monitor provides reference guidelines only. The actual
distance to objects may differ depending on terrain and object positioning.
On uneven surfaces such as slopes or when objects extend outward, the displayed
distance may not accurately reflect re ...
Transfer Range Position Sensor
Exploded View
Transfer assembly
Transfer range position sensor
: N·m (kg-m, in-lb)
Removal and Installation
WARNING:
Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air sus ...
Intelligent Rear View Mirror Camera
Exploded View
Back door panel
Intelligent rear view mirror camera
Intelligent rear view mirror camera harness connector
: vehicle front
: N·m (kg-m, in-lb)
Removal and Installation
REMOVALRemove back door inner finisher. Refer to Removal and Installation.
Disconnect intelligent r ...