SERVICE NOTICE AND PRECAUTIONS FOR TPMS : Precautions
-
Low tire pressure warning lamp turns ON when tire pressure is less than warning tire pressure value. Adjust tire pressure for all wheels to the specified value. Refer to TIRE AIR PRESSURE : Service Data.
-
Low tire pressure warning lamp blinks for 1 minute, then turns ON when occurring any malfunction or no sensor(s) except low tire pressure. Repair malfunction or if no sensor(s), Install tire pressure sensor and register the ID to turn low tire pressure warning lamp OFF. For ID registration, refer to Description.
-
ID registration is required when replacing or rotating tires and/or wheels, replacing tire pressure sensor or BCM. Refer to Description.
NOTE:
ID registration is unnecessary if there are no change in the positions of each wheels (tire pressure sensors) before wheel removal and after wheel installation.
-
Be sure to replace valve, valve core and valve cap of tire pressure sensor, when removing tire pressure sensor from wheel. Refer to TIRE PRESSURE SENSOR : Exploded View.
-
Replacing valve, valve core and valve cap of tire pressure sensor is recommended, when replacing each tire by reaching the wear limit. Refer to TIRE PRESSURE SENSOR : Exploded View.
-
Never apply excessive force to an inflator not to damage valve and tire pressure sensor when adjusting tire pressure.
-
Jack up the vehicle in order not to damage tire pressure sensor when extracting all the tire air on the vehicle (e.g. when filling up work of N2 gas to tire). For supporting points for lifting and jacking point, refer to Pantograph Jack (Pantograph Jack) or Garage Jack and Safety Stand (Garage Jack and Safety Stand) or 2-Pole Lift (2-Pole Lift).
-
Because the tire pressure sensor conforms to radio law of each countries, the following items must be observed.
-
The sensor may be used only in each countries.
-
It may not be used in any method other than the specified method.
-
It must not be disassembled or modified.
-
-
Never attach tire pressure sensor of other cars. Tire Pressure Monitoring System (TPMS) does not function if specified Genuine NISSAN tire pressure sensor is not attached.
Other materials
Fuses
Engine compartment
Basic information
WARNING
Never install a fuse in your Nissan Armada with an amperage rating different
from the specified value shown on the fuse box cover. Using an incorrect fuse can
lead to serious electrical damage, malfunction of control modules, or even fire
haz ...
Precautions
Precautions for Removing Battery Terminal
When disconnecting the 12V battery terminal, turn off the ACC power before disconnecting the 12V battery terminal, observing “How to disconnect 12V battery terminal� described below.
NOTE:
Some ECUs operate for a certain fixed time even after ignit ...
Body Side Welt
Removal and Installation
CAUTION:
Never excessively pull body side welt.
Never damage the body panel.
REMOVALFront Body Side WeltPull the mounting part inside the vehicle to the outside of the vehicle, and then remove front body side welt. CAUTION:
Remove the headlining portion of front body ...