Low tire pressure warning lamp turns ON when tire pressure is less than warning tire pressure value. Adjust tire pressure for all wheels to the specified value. Refer to TIRE AIR PRESSURE : Service Data.
Low tire pressure warning lamp blinks for 1 minute, then turns ON when occurring any malfunction or no sensor(s) except low tire pressure. Repair malfunction or if no sensor(s), Install tire pressure sensor and register the ID to turn low tire pressure warning lamp OFF. For ID registration, refer to Description.
ID registration is required when replacing or rotating tires and/or wheels, replacing tire pressure sensor or BCM. Refer to Description.
NOTE:
ID registration is unnecessary if there are no change in the positions of each wheels (tire pressure sensors) before wheel removal and after wheel installation.
Be sure to replace valve, valve core and valve cap of tire pressure sensor, when removing tire pressure sensor from wheel. Refer to TIRE PRESSURE SENSOR : Exploded View.
Replacing valve, valve core and valve cap of tire pressure sensor is recommended, when replacing each tire by reaching the wear limit. Refer to TIRE PRESSURE SENSOR : Exploded View.
Never apply excessive force to an inflator not to damage valve and tire pressure sensor when adjusting tire pressure.
Jack up the vehicle in order not to damage tire pressure sensor when extracting all the tire air on the vehicle (e.g. when filling up work of N2 gas to tire). For supporting points for lifting and jacking point, refer to Pantograph Jack (Pantograph Jack) or Garage Jack and Safety Stand (Garage Jack and Safety Stand) or 2-Pole Lift (2-Pole Lift).
Because the tire pressure sensor conforms to radio law of each countries, the following items must be observed.
The sensor may be used only in each countries.
It may not be used in any method other than the specified method.
It must not be disassembled or modified.
Never attach tire pressure sensor of other cars. Tire Pressure Monitoring System (TPMS) does not function if specified Genuine NISSAN tire pressure sensor is not attached.
Work Procedure
Perform camera calibration and perform writing to the around view monitor control unit, after removal/installation or replacement of each camera or camera mounting parts (front bumper molding center, door mirror, or others), or replacement of around view monitor control unit.
Parts name Operatio ...
Exploded View
Anchor bolt Retaining washer Seat belt adjuster LH Seat belt adjuster RH Shoulder anchor LH Shoulder anchor RH Spacer Seat belt pre-tensioner retractor LH Seat belt pre-tensioner retractor RH Lap pre-tensioner LH Lap pre-tensioner RH Seat belt buckle RH Seat belt buckle LH : N·m (kg- ...
Removal and Installation
WARNING:
REMOVAL
WARNING:
Never remove the radiator cap when the engine is hot. Serious burns could occur from high pressure engine coolant escaping from the radiator. Wrap a thick cloth around the cap. Slowly turn it a quarter turn to allow built-up pressure to escape. Carefully remove the cap by t ...