Removal and Installation
REMOVAL
-
Remove the door mirror finisher. Refer to Disassembly and Assembly.
-
Remove the side camera mounting screw
, and then remove the side camera 
.
INSTALLATION
Install in the reverse order of removal.
Perform parameter writing. (With ProPILOT Assist 2.1) Refer to Work Procedure.
Perform camera image calibration. Refer to Work Procedure.
CAUTION:
Perform the calibration and perform the writing to the around view monitor control unit when removing and replacing each camera, removing the camera mounting parts (front grille, door mirror, etc.) and replacing the around view monitor control unit.
Other materials
Noise, Vibration and Harshness (nvh) Troubleshooting
NVH Troubleshooting Chart
NVH Troubleshooting chartUse the Chart Below to Help You Find the Cause of the Symptom
Locate the area where noise occurs.
Confirm the type of noise.
Specify the operating condition of the engine.
Check specified noise source.
If necessary, ...
Door Mirror
Exploded View
Door mirror cover
Power folding motor
Door mirror finisher
Side turn signal lamp
Puddle lamp bracket (with puddle lamp)
Puddle lamp (with puddle lamp)
Door mirror housing assembly
Glass mirror
Door mirror base cover
Door mirror base gasket
Door mirror ...
Roof Antenna
Exploded View
Roof antenna
: N·m (kg-m, in-lb)
Removal and Installation
REMOVALRemove the headlining assembly. Refer to Removal and Installation.
Disconnect the antenna feeder connector.
Remove the mounting nut.
Remove the roof antenna from the vehicle.INSTALLATIONNote the following, ...