Work FlowInspection Procedure
CHECK 12V BATTERY TERMINALS CONNECTION
Check if 12V battery terminals are clean and tight.
Is the inspection result normal?
YES>>
GO TO 2.
NO>>
Repair 12V battery terminals connection.
CHECK “B” TERMINAL CONNECTION
Check if “B” terminal (alternator ground harness) is clean and ...
Inspection Procedure
INSTRUMENT PANEL
Most incidents are caused by contact and movement between:
Cluster lid A and instrument panel
Acrylic lens and combination meter housing
Instrument panel to front pillar garnish
Instrument panel to windshield
Instrument panel mounting pins
Wiring harnesses behind the combination met ...
Removal and Installation
WARNING:
REMOVAL
Remove rear final drive assembly. Refer to Removal and Installation.
NOTE:
It is necessary to remove rear final drive assembly to remove/install the side oil seal.
Remove side oil seal, using side oil seal puller (A) [SST: KV10122000 (NI-53383)] and sliding hammer (B) (commercial s ...