Special Service Tools
|
Tool number (TechMate No.) Tool name | Description | |
|---|---|---|
|
— (NI-44372) Pull gauge |
|
Measuring steering wheel turning force and ball joint swinging force |
|
KV40107300 (NI-51751) Boot band crimping tool |
|
Installing boot clamp (large diameter) |
Commercial Service Tools
| Tool name | Description | |
|---|---|---|
| Preload gauge |
|
Inspecting steering column rotating torque, pinion rotating torque and ball joint rotating torque |
| Power tool |
|
Loosening nuts, screws and bolts |
Sealant or/and Lubricant
| Name | Description |
|---|---|
| RheoGel TEK676 | Boot |
Other materials
Turbocharger
Exploded View
Bank 1 side
Water inlet hose
Clamp
Water inlet tube
O-ring
Heat insulator (upper)
Oil return pipe 1
Oil return hose
Oil return pipe 2
Heat insulator (lower)
Water outlet tube
Turbocharger assembly
Gasket 1
Stud bolt
Oil feed tube
Eye bolt ...
Head up Display Main Switch
Removal and Installation
REMOVALRemove instrument pad A. Refer to Removal and Installation.
Remove switch bracket mounting screws .
Disengage fixing pawl with removal tool to remove Head up Display main switch from switch bracket.
: Pawl
INSTALLATIONInstallation is in the reverse order of ...
Additional Service When Replacing Driver Monitor Camera Control Unit
Work Procedure
When driver monitor camera control unit is replaced, be sure to perform the specified incidental work in order to operate system normally.DRIVER MONOTOR CAMERA CONTROL UNIT CONFIGURATION
Perform saving vehicle internal information according to "Replace ECU" in CONSULT Operation Manual ...