Nissan Armada owner resource

Manuals, service information and practical owner guidance.

Fast access to Nissan Armada manuals, operating instructions, maintenance references and technical information.

Browse manuals
Nissan Armada manual library

Nissan Armada 2025-2026 Service and Repair Manual: The Braking Force of Parking Brake Is Low

Description

The parking brake braking force is low and the vehicle moves backward when parked on an incline.

Diagnosis Procedure

REAPPLY THE PARKING BRAKE (1)

  1. Pull the parking brake switch, and apply the parking brake.

  2. Pull the parking brake switch 2 seconds ore mode.

Is the vehicle moving backward?

YES>>

GO TO 2.

NO>>

NORMAL

PERFORM THE SELF-DIAGNOSIS

With CONSULT

Perform self-diagnosis for “ABS”.

Is any DTC detected?

YES>>

Check the DTC. Refer to DTC Index.

NO>>

GO TO 3.

CHECK REAR DISC BRAKE SYSTEM

Check the rear disc brake system.

  • Rear brake pad: Refer to Inspection and Adjustment.

  • Rear disc rotor: Refer to Inspection and Adjustment.

  • Rear brake caliper (and parking brake actuator): Refer to Inspection.

Is the inspection result normal?

YES>>

GO TO 4.

NO>>

Repair or replace error-detected pars.

  • Rear brake pad: Refer to Removal and Installation.

  • Rear disc rotor: Refer to Removal and Installation.

  • Rear brake caliper (and parking brake actuator): Refer to Removal and Installation.

REAPPLY THE PARKING BRAKE (2)

Pull the parking brake switch again.

Is the vehicle moving backward?

YES>>

Replace the ABS actuator and electric unit (control unit). Refer to Removal and Installation.

NO>>

NORMAL

    Other materials

    Replacement Operations
    Precautions for Body Repair WARNING: Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air suspension component parts. Refer to Precaution for when Jacking and Lifting Up the vehicle with Electronic Air Suspension System. WAR ...

    Writing of Calibration Data
    Work Procedure DESCRIPTIONIf only the around view monitor control unit is replaced, the calibration data stored in the camera can be written to the around view monitor control unit by selecting "Camera Calibration" of "Work Support" mode in CONSULT.WORK PROCEDUREWRITE CALIBRATION DATA With CONSULT ...

    Side Radar Alignment
    Work Procedure Always perform the side radar alignment after performing the following work. After removing and installing or replacing the side radar. After removing and installing, replacing or repainting the rear bumper. Side radar alignment conditions are following; The vehicle speed ...