Nissan Armada 2025-2026 Service and Repair Manual: TIG Welding
TIG is the abbreviation for tungsten inert gas shielded arc welding. TIG has the following special features.
Special features
Initial cost of the equipment is low, as is maintenance expense.
For ordinary electric power, high frequency alternating current is used.
Easy to learn in a short time.
Excellent strength and anti-corrosion properties.
Ideal for welding instruction and training.
Filler Metal
For a filler metal, TIG welding rods and MIG welding electrode wires are available. Use filler metal that is suitable to the parent metal.
Main selection standards of filler metal Parent metal Filler ...
MIG Welding
MIG is the abbreviation for metal inert gas shielded arc welding. MIG welding has the following special features.
(1) NORMAL MIG WELDING
MIG welding is the most commonly used welding method. As shown ...
Other materials:
Rear Disc Brake
Unit: mm (in)
Item Limit Brake pad Wear thickness 1.5 (0.059) Disc rotor Wear thickness 18.5 (0.728) Thickness variation (measured at 8 positions)* 0.009 (0.0004) Runout (with it attached to the vehicle) 0.07 (0.0028)
*To check if rotor imbalance, rotor runout or rotor deformation is oc ...
Stone Guard Coat
WARNING:
To prevent damage caused by stones, the lower outer body panel (fender, door, etc.) have an additional layer of Stone Guard Coating over the ED primer coating. When replacing or repairing these panels, apply Stone Guard coating to the same portions as before. Use a coating which is rust pre ...
Inspection
INSPECTION AFTER REMOVAL
When turn the shaft in direction , check returning to direction by spring power.
CAUTION:
The maximum turning force shall be 5 N·m (0.51 kg-m, 44 in-lb).
When turn the shaft in direction , check locking the shaft. INSPECTION AFTER INSTALLATION
ADJUSTMENT AFTER INSTALLATIO ...
0.0051