Nissan Armada 2025-2026 Service and Repair Manual: Filler Metal
For a filler metal, TIG welding rods and MIG welding electrode wires are available. Use filler metal that is suitable to the parent metal.
| Parent metal | Filler metal |
|---|---|
| Front fender, hood: 5000 series, 6000 series | A5356 |
| Door: 6000 series | A5356 |
Comparision of Chemical and Physical Properties between Aluminum and Iron
Property Aluminum alloy Iron Effect of welding Melting temperature °C (°F) 560 - 640
(1,040 - 1,184) 600 × 2.5
(1,112 × 2.5) Aluminum alloy melts before it turns red.
This makes it difficult ...
TIG Welding
TIG is the abbreviation for tungsten inert gas shielded arc welding. TIG has the following special features.
Special features
Initial cost of the equipment is low, as is maintenance expense.
For ordi ...
Other materials:
Removal and Installation
REMOVAL
Remove the steering column cover upper. Refer to Removal and Installation.
Disconnect the driver monitor camera connector.
Remove the driver monitor camera mounting screws , and remove the driver monitor camera from the steering column cover upper .
INSTALLATION
Installation is in the rev ...
Procedure for Applying Body Filler
(1) REMOVAL OF PAINT
Using an air sander, remove old paint and "scuffing" the panel surface for better filler adhesion. Form a featheredge on the panel surface approximately 20 mm (0.79 in) wider than the correction area in order to eliminate traces of body filler application.
(2) CHEMICAL CONVERSIO ...
Inspection
INSPECTION BEFORE REMOVAL
Check brake fluid level switch. Refer to Brake Fluid Level Switch.
INSPECTION AFTER REMOVAL
Check the following items, and replace the part if necessary.
Check for damage, deformation, interference with the other parts, and looseness of connection.
Check for fluid leakage f ...
0.0116