Description
After working the following, transfer unit parameter must be written to transfer control unit.
-
Transfer control unit replacing
-
Transfer assembly replacing
-
Transfer control actuator replacing
-
Transfer range position sensor replacing
-
Transfer cam position sensor replacing
-
Transfer case component parts disassembling
NOTE:
Write charactereistic value in transfre control unit, if the above each parts is replaced.
For the work procedure, refer to Work Procedure.
Work Procedure
WARNING:
-
Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air suspension component parts. Refer to Precaution for when Jacking and Lifting Up the vehicle with Electronic Air Suspension System.
UNIT CHARACTERISTIC VALUE CONFIRMATION
Confirm the 5-digit alphanumeric unit characteristic value written in the QR code pasted on the side or top of the transfer assembly.

![]() |
: Side surface |
![]() |
: Top surface |
NOTE:
There is space on the top to check with the camera.
>>
GO TO 2.
WRITING UNIT PARAMETER
With CONSULT
-
Ignition switch ON.
-
Select “Work support” in “AWD/4WD”.
-
Perform “Unit parameter writing” to the CONSULT display.
>>
WORK END
Other materials
How to park with predictive course lines
WARNING
If non-standard tire sizes are installed on the Nissan Armada, the predictive
course lines may not display accurately.
On slippery or snow-covered roads, the Nissan Armada predicted path may
differ from the actual vehicle movement.
If the Nissan Armada battery is disconnected o ...
Second Heated Seat System
Symptom Table
Symptom Possible causeInspection item
Second heated seat system does not operate
Display unit and rear A/C control operation does not operate
Fuse
Second seat heater power supply/ground/LIN signal circuit
Second seat cushion heater
Second seatback heater
A/C auto amp.
Check second ...
Anti-Pinch Function Does Not Operate
Moonroof
Diagnosis Procedure
PERFORM INITIALIZATION PROCEDURE
Perform initialization procedure. Refer to Description.
Is the inspection result normal?
YES>>
INSPECTION END
NO>>
Replace moonroof motor assembly. Refer to Removal and Installation.
Sunshade
Diagnosis Procedure
PERFORM INI ...

