Description
When replacing transfer control unit, the following work is required. For the work procedure, refer to Work Procedure.
WORK AFTER REPLACEMENT
-
Unit parameter writing
-
Initial calibration
Work Procedure
WRITING THE REQUIRED INFORMATION FOR CONTROL UNIT REPLACEMENT
With CONSULT
-
Ignition switch ON.
-
Select "AWD/4WD".
-
Select "Replace ECU".
-
Perform the work according to the procedure displayed in CONSULT.
CAUTION:
The following conditions must be maintained during ECU modernization procedure.
-
Ignition switch ON.
-
All electric loads are OFF
-
Brake pedal is not depressed.
-
Battery voltage: 12-13.5 V (Be sure to check the value of battery voltage by CONSULT.)
NOTE:
Writing of control unit information is performed automatically.
-
>>
GO TO 2.
WRITING UNIT PARAMETER
Perform writing of the unit parameter to transfer control unit. Refer to Work Procedure.
>>
GO TO 3.
INITIAL CALIBRATION
-
Continue the following condition.
Transmission position : P
4WD mode : AUTO
-
Depress the brake pedal.
-
Start the engine and wait for approximately 10 seconds under the brake pedal depressed.
>>
GO TO 4.
PERFORM SELF-DIAGNOSIS
With CONSULT
-
Erase self-diagnostic results for “AWD/4WD�.
-
Ignition switch ON to OFF.
CAUTION:
Wait for 60 seconds after ignition switch OFF.
-
Depress the brake pedal.
-
Start the engine.
CAUTION:
Never drive the vehicle.
-
Perform self-diagnosis for “AWD/4WD�.
Is any DTCs detected?
YES>>Check DTC detected item. Refer to DTC Index.
NO>>WORK END
Other materials
Basic information
This section of the Nissan Armada manual provides essential safety guidance regarding
seat positioning, seat belt usage, and overall occupant protection. Proper seating
posture in the Nissan Armada is critical for maximizing the effectiveness of the
supplemental restraint system and reduci ...
Noise, Vibration and Harshness (nvh) Troubleshooting
NVH Troubleshooting Chart
Use chart below you find the cause of the symptom. If necessary, repair or replace these parts. Possible cause and SUSPECTED PARTS Symptom Reference
DRIVE SHAFT REAR AXLE
Noise Shake Noise Shake Vibration Shimmy Judder Poor quality ride or
Excessive joint an ...
Brake Fluid
Inspection
WARNING:
Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air suspension component parts. Refer to Precaution for when Jacking and Lifting Up the vehicle with Electronic Air Suspension System.
BRAKE FLUID LEVEL
C ...