Nissan Armada 2025-2026 Service and Repair Manual: Wheel Sensor

Front Wheel Sensor

Exploded View

	Front LH wheel sensor		Bracket		Steering knuckle
	: vehicle front
	: N·m (kg-m, in-lb)

NOTE:

Front RH wheel sensor is symmetrically opposite of LH.

Removal and Installation

WARNING:

• Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air suspension component parts. Refer to Precaution for when Jacking and Lifting Up the vehicle with Electronic Air Suspension System.

REMOVAL

Remove tires. Refer to ROAD WHEEL TIRE : Removal & Installation.

Disconnect front wheel sensor harness connectors and remove harness clip.

Remove grommet from bracket.

Remove front wheel sensor mounting bolt.

Remove front wheel sensor from steering knuckle.

CAUTION:

Never rotate and never pull front wheel sensor as much as possible, when pulling out.

Remove front wheel sensor harness from the vehicle.

CAUTION:

Never twist or pull front wheel sensor harness, when removing.

INSTALLATION

Note the following, and install in the reverse order of the removal.

• Check that there is no foreign material like iron powder or damage on inner surface of front wheel sensor mounting hole of steering knuckle and sensor rotor. Install after cleaning when there are foreign material like iron powder, or replace when there is a malfunction.

• Never twist front wheel sensor harness when installing front wheel sensor. Check that grommet is fully inserted to bracket . Check that front wheel sensor harness is not twisted after installation.

  

  CAUTION:

  Check that front wheel sensor identification line faces toward the vehicle front.

  

Rear Wheel Sensor

Exploded View

	Rear brake caliper		Axle housing		Bracket
	Parking brake actuator harness and rear wheel sensor
	: vehicle front
	: N·m (kg-m, ft-lb)
	: N·m (kg-m, in-lb)

NOTE:

Rear RH wheel sensor is symmetrically opposite of LH.

Removal and Installation

WARNING:

• Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air suspension component parts. Refer to Precaution for when Jacking and Lifting Up the vehicle with Electronic Air Suspension System.

REMOVAL

Remove tire. Refer to ROAD WHEEL TIRE : Removal & Installation.

When removing parking brake actuator harness and rear wheel sensor on the left side, remove the spare tire. Refer to Removal & Installation.

Disconnect parking brake actuator harness and rear wheel sensor harness connectors.

CAUTION:

Never twist and never pull rear wheel sensor harness, when removing.

Remove parking brake actuator harness and rear wheel sensor mounting bolts.

Remove parking brake actuator harness and rear wheel sensor.

CAUTION:

Never rotate or pull rear wheel sensor as much as possible, when pulling out.

INSTALLATION

Note the following, and install in the reverse order of removal.

• Check that there is no foreign material like iron powder or damage on inner surface of rear wheel sensor mounting hole. Install after cleaning when there are foreign material like iron powder, or replace when there is a malfunction.

• Never twist rear wheel sensor harness when installing rear wheel sensor. Check that grommet is fully inserted to bracket . Check that rear wheel sensor harness is not twisted after installation.