Nissan Armada owner resource

Manuals, service information and practical owner guidance.

Fast access to Nissan Armada owner manuals, service procedures, maintenance references, technical information and practical guides for different Armada generations.

Browse manuals →
Nissan Armada manual library

Nissan Armada 2025-2026 Service and Repair Manual: Wiper and Washer System Symptoms

Symptom Table

NOTE:

Perform the self-diagnosis with CONSULT before the symptom diagnosis. Perform the trouble diagnosis if any DTC is detected.

Symptom Possible cause Inspection item
Front wiper (HI, LO) does not operate normally
  • BCM

  • Combination switch

  • Harness between combination switch and BCM

Combination switch

Refer to Symptom Table.
  • Harness between BCM and front wiper motor

  • Harness between fuse block (J/B) and front wiper relay

  • Harness between fuse and fusible link block and front wiper relay

  • Harness between front wiper relay and ground

  • Harness between front wiper relay and front wiper motor

  • Harness between front wiper motor and ground

  • Fuse

  • Front wiper motor

  • Front wiper relay

  • BCM

Front wiper motor circuit

Refer to Diagnosis Procedure.

Front wiper request signal

  • BCM

  • Front wiper motor

BCM

Data monitor “Front wiper request�
Front wiper (AUTO) does not operate normally*1
  • BCM

  • Combination switch

  • Harness between combination switch and BCM

Combination switch

Refer to Symptom Table.
  • BCM

  • Light & rain sensor

  • Harness between light & rain sensor and BCM

Light & rain sensor

Refer to Diagnosis Procedure.
Wiper AUTO operation setting Check that the rain sensor is turned ON in the vehicle setting of the vehicle information display of the combination meter.
Front wiper (INT) does not operate normally*2
  • BCM

  • Combination switch

  • Harness between combination switch and BCM

Combination switch

Refer to Symptom Table.
  • Wiper INT operation setting

  • BCM

Check that the rain sensor is turned OFF in the vehicle setting of the vehicle information display of the combination meter.
Wiper is not linked to the washer operation BCM

Replace BCM

Refer to Removal and Installation.
Front washer does not operate normally
  • BCM

  • Washer switch

  • Washer pump

  • Harness between front washer pump and washer switch

  • Washer switch

    Refer to Component Inspection.

  • Washer pump circuit

    Refer to Diagnosis Procedure.

Rear wiper does not operate ON only
  • BCM

  • Combination switch

  • Harness between combination switch and BCM

Combination switch

Refer to Symptom Table.
INT only
  • BCM

  • Combination switch

  • Harness between combination switch and BCM

Combination switch

Refer to Symptom Table.
ON and INT
  • BCM

  • Combination switch

  • Harness between combination switch and BCM

Combination switch

Refer to Symptom Table.
Rear wiper does not stop ON only
  • Combination switch

  • BCM

Combination switch

Refer to Symptom Table.
INT only
  • Combination switch

  • BCM

Combination switch

Refer to Symptom Table.
Rear wiper does not operate normally Wiper is not linked to the washer operation BCM

Replace BCM

Refer to Removal and Installation.
Rear wiper does not operate even when shift position is “R�. Rear wiper operation linked with reverse setting Check that the rear wiper operation linked with reverse in the vehicle setting of the vehicle information display of the combination meter.
Rear washer does not operate normally
  • BCM

  • Washer switch

  • Washer pump

  • Harness between front washer pump and washer switch

  • Washer switch

    Refer to Component Inspection.

  • Washer pump circuit

    Refer to Diagnosis Procedure.

Washer fluid warning does not operate normally
  • Combination meter

  • Washer level switch

  • Harness between combination meter and washer level switch

  • Washer level switch circuit

    Refer to Diagnosis Procedure.

  • Combination meter

    Refer to Work Flow.

Drop wipe operation does not operate normally
  • Drop wipe operation setting

  • BCM

  • Check that the Drop wipe operation is turned ON in the vehicle setting of the vehicle information display of the combination meter.

  • Replace BCM

    Refer to Removal and Installation.

*1: Rain sensor is set ON

*2: Rain sensor is set OFF

    Other materials

    Assist grips
    The Nissan Armada assist grips are strategically positioned above the front passenger door and rear side doors to provide additional support for passengers during travel. CAUTION Do not use the Nissan Armada assist grips as a support when entering or exiting the vehicle. Improper use may d ...

    MOD system limitations
    WARNING The following section outlines important limitations of the Moving Object Detection (MOD) system in the Nissan Armada. Ignoring these limitations or relying on the system beyond its capabilities may significantly increase the risk of accidents, serious injury, or even fatal outcomes. ...

    Interior Lighting System Symptoms
    Symptom Table NOTE: Perform the self-diagnosis with CONSULT before the symptom diagnosis. Perform the trouble diagnosis if any DTC is detected. Symptom Possible cause Inspection item All the following lamps does not turn ON. Map lamp Personal lamp Rear room lamp Luggage room lamp Front ...