Nissan Armada 2025-2026 Service and Repair Manual: Work Procedure
Description
When replacing the electrical brake control unit, the procedures of AFTER REPLACEMENT must be performed.
CAUTION:
If the electrical brake control unit is undamaged, do not decide to replace it based on DTC detected in the past.
AFTER REPLACEMENT
After replacing the electrical brake control unit, the following items must be performed:
Electrical brake control unit programming
Air bleeding of brake fluid
Work Procedure (After Replace Electrical Brake Control Unit)
PERFORM ELECTRICAL BRAKE CONTROL UNIT PROGRAMMING
With CONSULT
Perform electrical brake control unit programming, according to “Programming” of CONSULT Operation Manual. Refer to CONSULT Operation Manual.
CAUTION:
During programming, maintain the following conditions:
Ignition switch: ON
Electric parking brake: Apply (Models with electric parking brake function)
Electric load: OFF
Brake pedal: Not depressed
12V battery voltage: 12 – 13.5 V (Check the value displayed on the CONSULT screen.)
GO TO 2.
PERFORM NECESSARY WORK
With CONSULT
Perform air bleeding. Refer to Bleeding Brake System.
Perform stroke sensor calibration. Refer to Work Procedure.
Perform self-diagnosis for “All DTC Reading”.
Erase the memory of self-diagnosis results.
End of work.
Other materials:
Work Flow
CUSTOMER INTERVIEW
Squeak – (Like tennis shoes on a clean floor)
Creak – (Like walking on an old wooden floor)
Rattle – (Like shaking a baby rattle)
Knock – (Like a knock on a door)
Tick – (Like a clock second hand)
action or road conditions.
Thump – (Heavy, muffled knock noise)
Buzz ...
Removal and Installation
WARNING:
REMOVAL
Disconnect negative battery terminal. Refer to Removal and Installation.
Remove rear propeller shaft. Refer to Removal and Installation .
Remove front propeller shaft. Refer to Removal and Installation.
Disconnect transfer cam position sensor harness connectors and separate harnesse ...
Removal & Installation
REMOVAL
Remove transmission assembly, refer to the following:
2WD models: Refer to Removal and Installation.
4WD models: Refer to Removal and Installation.
Remove drive plate. Refer to Removal and Installation.
Remove rear oil seal with a suitable tool.
CAUTION:
Be careful not to damage cranks ...
0.0063