Nissan Armada 2025-2026 Service and Repair Manual: Work Procedure

Additional Service When Replacing Third Seat Control Unit Rh

When after replacing third seat control unit RH, third seat RH position initialization must be performed. For details, refer to Work Procedure. ...

Additional Service When Replacing Third Seat Control Unit Lh

When after replacing third seat control unit LH, third seat LH position initialization must be performed. For details, refer to Work Procedure. ...

Other materials:

Handling of Welding Equipment
(1) STORAGE OF GAS CYLINDERS In a well ventilated area, post a “No Fire” sign. Avoid the direct rays of the sun. Maintain temperature below 40°C (104°F). Inflammable gas cylinders and oxygen cylinders must not be stored in the same place. Acetylene cylinders must be stored upright. Check that ...

Removal and Installation
WARNING: CAUTION: Never disconnect or pull the torque sensor harness and harness connector . REMOVAL Set vehicle to the straight-ahead position. Remove 12V battery terminal. Refer to Removal and Installation. Remove tires. Refer to ROAD WHEEL TIRE : Removal & Installation. Remove cotter pins a ...

Work Procedure
CAUTION: Always use CONSULT for the decel G sensor calibration and side G sensor calibration. (It cannot be adjusted other than with CONSULT.) CHECK THE VEHICLE STATUS Steer the steering wheel to the straight-ahead position. Stop the vehicle on level surface. Stop the engine. Ignition switch OFF (A ...