Nissan Armada 2025-2026 Service and Repair Manual: Work Procedure
Memory Storage Procedure
Two positions for the seat, steering column, and door mirror can be stored for memory operation by following procedure.
NOTE:
Memory registration can be performed with no restrictions of the shift position, vehicle speed, and ignition switch position.
REGISTRATION METHOD
Adjust seat, steering column, and door mirror position manually.
Push set switch.
NOTE:Memory indicator for which driver seat position is already retained in memory is illuminated for 5 seconds.
Memory indicator for which driver seat position is not retained in memory is illuminated for 0.5 seconds.
Push the memory switch (1 or 2) for at least 1 second within 5 seconds after pushing the set switch.
NOTE:When registration is performed correctly, the memory indicator blinks for 5 seconds and a buzzer sounds.
If memory is stored in the same memory switch, the previous memory will be deleted.
Confirm the operation of each part with memory operation.
WORK END
Memory Storing
Always perform the memory storage when the driver seat control unit or steering column control module is replaced. The memory function will not operate normally if no memory storage is performed. For ...
System Setting
The settings of the automatic driving positioner system can be changed, using information display in the combination meter and the set switch. Always check the settings before and after replacing driv ...
Other materials:
Types of Filler and Putty
Type (Standard thickness limits) Characteristics Body Filler Putty
(For repairing of large dents or scratches)
[10 mm (0.39 in)] Surform type This type of filler requires surforming (rough grinding). It will clog sandpaper if it is sanded only.
Can be thickly applied to panel.
After drying, grind ...
Diagnosis Procedure
NOTE:
SYMPTOM TABLE 1 (BOTH INTELLIGENT KEYS HAVE THE SAME SYMPTOMS)
No. Door lock operation (remote keyless entry) Door lock operation (request switch of front/rear door) or trunk/back door open operation (opener switch of trunk/back door panel) Engine started with push-button ignition switch o ...
Removal and Installation
WARNING:
REMOVAL
Bank 1 side
Remove front tire assembly (RH). Refer to ROAD WHEEL TIRE : Removal & Installation.
Remove fender protector (RH). Refer to Removal and Installation.
Remove main muffler. Refer to EXHAUST SYSTEM : Removal & Installation.
Remove 2nd catalyst converter (bank 1) .
...
0.005